How To Replace Parking Brake Shoes & Hardware 2002-09 Dodge Ram 1500

Buy Now!
New Parking Brake Shoe Set from 1AAuto.com 1aau.to/ia/1ABPS03200
For drum brakes and parking brakes, shoes will eventually need to be replaced. If you are overhauling your rear brake system, or just need to replace worn out shoes, this video will show you how to install new drum or parking brake shoes on your 2002-2009 Dodge Ram 1500.
• Check here for more videos on the 2002-09 Dodge Ram 1500: • Dodge Ram 1500 3rd Gen...
This process should be similar on the following vehicles:
2002 Dodge Ram 1500
2003 Dodge Ram 1500
2004 Dodge Ram 1500
2005 Dodge Ram 1500
2006 Dodge Ram 1500
2007 Dodge Ram 1500
2008 Dodge Ram 1500
Tools you will need:
• Flat Blade Screwdriver 1aau.to/oa/1AXAA00013
• Pocket Screwdriver
• Pry Bar 1aau.to/oa/1AXAA00020
• Straight Cutters
• 1/2 Inch Air Impact Gun 1aau.to/oa/1AXAA00252
• Ratchet 1aau.to/oa/1AXAA00016
• Socket Driver
• Socket Extensions 1aau.to/oa/1AXAA00015
• Torque Wrench 1aau.to/oa/1AXAA00044
• Brake Grease
• Brake Parts Cleaner
• Paper Towels 1aau.to/oa/1AXSS00035
• Rust Penetrant
• Center Punch 1aau.to/oa/1AXAA00055
• Floor Jack 1aau.to/oa/1AXAA00068
• Hammer 1aau.to/oa/1AXAA00091
• Jack Stands 1aau.to/oa/1AXAA00065
• Wheel Chocks
• Wire Brush 1aau.to/oa/1AXAA00079
Subscribe: / @trq
Check out our playlist:
Dodge Ram 1500 3rd Generation 2002-09: • Dodge Ram 1500 3rd Gen...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts √ *Do it Yourself* √ *Save Money*

[@al.g.2757]

GREAT VIDEO, the visual and audio quality was excellent! That's how you do a DIY video, No BS talk, show the most important steps, and concise as possible! GREAT JOB all the way around!

[@verticle2612]

Excellent! I spent 32 years as a Maintenance Test Pilot in the U.S. Army. You are a great instructor.

[@johndarling1570]

This is the best Video if you own a Durango or Ram. I have done this almost exactly like the mechanic.

[@kobz808]

Thanks, i just did mine on a 2004 1500 4x4 worked great after adjusting the cable too

[@reebertJunkman]

this was a good video... it showed some different angles that I needed for my repair... I did find that the repetitive irritating parts missing, but alas I found all your footage in real life. I thought that literally one try and the pins would be through the slots... well I really did not think that but one can dream

[@TRQ]

+Reebert McJunk Thanks for watching our video! 1aau.to/m/Shop-TRQ

[@GrowthGuided]

Appreciate you putting this video up. Will be helpful for my 06

[@jamesshemwell6868]

Great video ... after watching it I'm almost sure I'll be able to change mine and will save almost $250 by doing it myself. Also I'll be replacing the rotors at the same time and if they need it the regular brake pads as well.

[@vincentsanchez8489]

Made job on fix , well done video . Straight to the point thank you very much.😊

[@olenairsoftguy88]

Great great great , quality video, thank you!!

[@MartinGarcia-xn8vo]

Awesome video, thank you for sharing your knowledge!!👍🏽👍🏽👍🏽👍🏽

[@Sage-qd6tf]

You say once you have the backing plate cleaned up as if mine didn’t literally rust completely off 😂 thanks for the vid

[@garytaylor797]

Do the long end of the springs go toward the back on both sides or just the drivers side. i have the dodge manual and it doesn't even show the same brakes as mine.

[@Nonurbizniz]

I'm unable to take off the rotors , seems like they are caught up on the E-brake with the Lever (pulling cable) being stuck in active brake on position that rusted itself together, any help with correction and getting rotors off?

[@wingnutbren]

Your my favorite car guy.

[@kurtiscressman9348]

I have replaced pads, tightened cable, and adjusted them. No matter what I do I cannot get the e brake to hold without them also rubbing when e brake is not engaged. I watched them with rotor off and shoes barely move at all. What is wrong?

[@captgrant]

I noticed the clips on the caliper were tucked behind the housing. The OEM specs show them on the outside of the caliper.

[@danielmason1326]

Having trouble, getting the rotors to go Back on after installing new e brake shoes , have you ever encountered a scenario where the actuator/ pivot mechanism was tweaked/ bent and didn’t function properly as to not allowing the shoes to fully release all the way ? Curious if this is my problem cause the fork on the pivot looks bent, which isint allowing the shoe to seat all the way into the fork on pivot /actuator.

[@haroldlanglois8986]

great video

[@Nonurbizniz]

Is it possible anyone could comment on the cog wheel , what happens when it is turning upwards vs downward, drivers side vs passengers?

[@leejayking]

Thanks buddy my customer got me the wrong hardware kit. And I had to destroy the old one's rust is a killer but got to return these spring's and see if can locate right one's

[@TRQ]

+Jessie King Thanks for watching our video! 1aau.to/m/Shop-TRQ

[@theintan3052]

Good job thank you

[@1shagg420]

Why is my adjuster on the bottom? It's the same setup just upside down?

[@ironman2427]

Screw that. Pull the rear axles and you don't have to fight the parking brake shoes and hardware plus you have an excuse to drain and refill the differential.

[@jamesflenory9108]

Didn’t show how you put the green spring in

[@jvp3778]

You skipped the green spring

[@jamesshemwell6868]

PS ... hopefully I won't have to drop too many "F-BOMBS" while I'm replacing them. lol

[@j.sierra5703]

I didn't know that Mitch from Modern Family was a car guy.....

[@J.es.us-Rey-es]

✝️💙🙏🏼🛐🇮🇱thanks guys you are the best

[@joshuamercier1442]

You could of removed the axels so we can see

[@brianleblanc9050]

holly #$%R$...i rather pull engine then do this again..PIA LEVEL high!

[@creaturesofsuburbia360]

Can you talk any faster, haha ? Asking for a friend. Training videos are often for the people who do not have a lot of experience but you talk like you would talk to another mechanic. Great video though !

[@robstuckey]

Worst video ever. Zero explanation when dude puts in the adjuster.. "let's get our adjuster in there now... (Guy puts it in with zero explanation and half second snippet of video).. perfect!"