√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*
@muvfast7 ай бұрын
It's always gonna be the vice grips, just save the time and effort, especially if you're in rusty land... Great video as always!!
@reccocon34424 жыл бұрын
Thanks for your thoroughness, professionalism guys! No loud music and outlandish personalities. Again,Thanks.
@1AAuto4 жыл бұрын
+Recco Con Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c
@viduravidasanayake3630Ай бұрын
"Hey, thanks for the video! Quick question: is it possible to do this by lifting one side of the car at a time using a normal jack? Unfortunately, I don't have a center jack, and I'm having trouble finding one. Would lifting each side separately still work for this process, or would it be risky or ineffective? Any advice would be greatly appreciated!" 😊
@ianyoung8214 жыл бұрын
Good video thank you! I gotta say though i wish my car had that little rust. I kind of chuckled when you said it looked pretty rusty lol I have the feeling I will have to utilize the locking pliers hint.
@1AAuto4 жыл бұрын
+Ian young Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c
@DavidinTexas5 жыл бұрын
Thx, i stripped out my allen key & needed that Locking pliers hint
@benji88755 жыл бұрын
so you torque the front 55 foot pounds and the back 29 foot pounds, after installation?
@petersmiles45954 жыл бұрын
Are the fronts longer than the rears?
@agntsmth774 жыл бұрын
You only need mm tools for toyota camry? Thanx
@1AAuto4 жыл бұрын
+agntsmth77 Thanks for watching! Most of the parts on a Toyota will require metric tools, but not all!
@huiren96765 жыл бұрын
Locking pliers good tool...
@whocares1914 Жыл бұрын
So they make this cool thing called a heat gun and if you put the rust penetrant on then use the heat gun to it before attempting to remove the bolt …. Then it may be easier to take off without all the stripping to the Allen key
@michaelmcmanus40186 жыл бұрын
The ball joint of the sway bar link spins as I try to take off the bolt. What to do?
@1AAuto6 жыл бұрын
+Michael McManus Hello! There will be a way to hold the ball part of the link still while tightening. There will be a hex surface machined to the end or there will be a hole at the end in the shape of a hex key. Thnk you! 1AAuto.com