How To Replace Switch Inhibitor [ Pajero 2019] A/T V4A5A/V5A5A

Created by InShot:inshotapp.page... In this video episode I show you how to install the new inhitor switch on Mitsubishi Pajero 2019, A/T V4A51/V5A51. Please watch like share and subscribe to our KZbin channel. Thank you and God bless everyone.

[@superfoood4618]

Salamat sa pagshare always watching 💯👏🥇🏆

[@autofixgarage5438]

Much appreciated sir, Merry Christmas 🎅 🎄. God bless.

[@user-kg2im5eq8m]

Very useful, thanks a lot

[@autofixgarage5438]

Your welcome Boss, thanks for your kind support.God bless.

[@user-kg2im5eq8m]

Where is your garage I need to fix the same problem?

[@autofixgarage5438]

I am in the Philippines

[@dilsonvalverdecastro3960]

Excelent, excelente, very Good, muy bueno

[@0789yassor]

Sir, I hope you can help me with my problem. I have not found a solution for it, and when I put the transmission on normal, the problem does not appear. Only when I put it on D and I want to drive, the transmission becomes undesirable. I have to move the gear stick only to N, then D, in order for the car to move, and the matter is repeated up to 7 times, then Everything will be fine

[@josemestre8589]

I'm trying to replace the switch but can't disconnect the electric connector. It is in a very difficult place to reach and therefore I'm not sure what needs to be done, like pressing any pin to allow the disconnection. Is anyone here able to give me a hint? Thanks

[@autofixgarage5438]

Use long screw driver Boss then pull it out the mounting of harness connector so that you can easily press the lock of connector.

[@XIXjlo]

What are the symptoms of a bad inhibitor switch?

[@autofixgarage5438]

There are bad symptoms of defective Inhibitor Switch, engine can't start when the shifting lever is at neutral position or in Park position, you might be experiencing the engine only cranking only in Park or the engine only cranking in neutral, the engine cranking in all shift position, the shift indicators light of Neutral and Drive are light on at the same time and reverse lamp not turning on when in reverse position, A/T can't move forward during in Drive position or can't move backward during shifting in Reverse position.

[@0789yassor]

I have a problem. When I put the transmission in D, the car moves a little, then the transmission disconnects and the car does not move. The gear sensor was replaced and the problem persists.

[@autofixgarage5438]

Did you check sir the condition of transmission fluid level,is it smell burned, blachesh color, foreign metal particles in fluid, if so something mechanical failure inside the transmission, like clutches and other components,is there's any DTCs or fault codes?I hope this message help you. Thank you and God bless.

[@0789yassor]

@@autofixgarage5438 There are no codes, and the transmission oil and filter were replaced, but the problem occurs when I start driving, and it repeats five times, then everything is fine.

[@0789yassor]

@@autofixgarage5438 Sir, I hope you can help me with my problem. I have not found a solution for it, and when I put the transmission on normal, the problem does not appear. Only when I put it on D and I want to drive, the transmission becomes undesirable. I have to move the gear stick only to N, then D, in order for the car to move, and the matter is repeated up to 7 times, then Everything will be fine

[@autofixgarage5438]

OK sir,what model year of your Pajero,the mileage how many kilometers?try to replace first the switch Inhibitor maybe poor contact from switch, Neutral to Drive that's why your car can't move,if not yet solved it must be perform line pressure test,it must be monitor the pressure of the fluid,next procedure is torque converter stall test,if those test are not meet the standard value it is subject to pulldown your A/T for dismantle for proper evaluation.I hope this message helpful.

[@0789yassor]

@@autofixgarage5438 Pajero 2008, mileage 340,000. The oil and oil filter were replaced. I found a metal piece in the oil cartridge. I had to replace the gear selector like the one that was replaced in your video clip.

[@Jaber.Alobeidli]

I put my gear in p and i open the switch what i can do know?

[@autofixgarage5438]

Just clean first the switch maybe poor contact from the terminals.

[@Jaber.Alobeidli]

I mean it should be in n while im opening

[@autofixgarage5438]

Yes,put in n position

[@ismailyilmaz5039]

Türkiye'den Selamun aleykum,2011 model mitsubishi lancer 1,5 otamatik cvt şanzıman aracımda aynı sorun var,inhibitor switc arızalı sanırım.Ne tür bir parça kullanmam gerek,marka model tavsiyeniz nedir

[@autofixgarage5438]

Kindly translate to English sir

[@michal.mozdzierz]

Hello is the worn steering wheel common problem on Pajero? Mine is the same

[@autofixgarage5438]

Yes Boss it is common issue but not in all units.

[@achikmustapa849]

Hi sir My pajero v75w also have same problem but when i replace their I/switch,my pajero back to normal but sometime when i shift to D,indicator lamp on meter still show on N then i push to N and get back to D then indicator lamp show D(i need twice push gear lever to D)..can u help me sir? Maybe wrong setting(install) I/switch when i replace that part. Tqvm sir

[@autofixgarage5438]

Only adjustment of shifting cable sir, try it and everything is fine. Thank you.

[@achikmustapa849]

@@autofixgarage5438 tqvm sir

[@user-cm4df6tj7g]

How did you get the plug to come out? That looked way too easy 😂

[@autofixgarage5438]

I used the long screw driver to pull out sir, I didn't took a video due to no space for the camera, thank you sir. To God be all the glory.

[@cbn5410]

Hello dear, what type of grease do I use to protect the installation?

[@autofixgarage5438]

Any type of grease you can use Boss to avoid corrosion, thank you, I really appreciate it, God bless.

[@medoomedo3017]

Hello my friend, I want to locate your workshop address, my car is Pajero, and I have the same problem

[@autofixgarage5438]

Bring to our Jeddah branch sir, thanks for your kind support 🙏.God bless.

[@edmunek]

f sake.... how long is that completely meaningless staff?... 1/3 of the video is just waste of time