i was hoping on the re install that i might get a more visual step by step but the end is just a vague as the beginning, thank thou. at least i got an idea
@gettindirty4x4adventureАй бұрын
@Abfs900 What did you want to see? It's the same as removing it. Just follow the removal steps and that's that's how it's done. - Plug the water sensor back together - Put the filter in the housing - Tighten the two 14mm nuts - Put the fuel lines back in - Start priming the filter till hard - Start the vehicle then you may need to prime it again until it will stay running.
@JetA1Terminator2 жыл бұрын
Also my oiling can, oil filter strap wrench and 1/2” ratchet
@JetA1Terminator2 жыл бұрын
They are my blue-point soft jaw pliers 🤔🤣🤣🤣👍👍
@gettindirty4x4adventure2 жыл бұрын
Well you did leave them out on the table.. they got put away afterwards so I'll say it now, your welcome 😉😂
@JetA1Terminator2 жыл бұрын
@@gettindirty4x4adventure 😂🤣😂🤣
@sssboi2104 Жыл бұрын
Thanks for the video, very helpful! Is it possible to do this without a vice?
@gettindirty4x4adventure Жыл бұрын
Might be hard to hold without a vice but I'm sure you could find a way to hold the mount while you undo/tighten the filter. Could remove the battery and maybe try Undoing the filter in the engine bay while it's still bolted in but without trying it and seeing it in person right this minute, it's hard to say.
@Jacko91110 ай бұрын
Bleed screw on the sensor or just prime it up and should be good?
@gettindirty4x4adventure10 ай бұрын
No bleed screw on a factory housing but the pre filter has one which I open to prime that before it starts filling the factory one. Easy as that👍
@stur46225 ай бұрын
Good vision, but lots of repetition yet some items not explained. Overall I can't recommend this as a tutorial.
@gettindirty4x4adventure5 ай бұрын
Ok thanks for the comment. Stated as a DIY video of how I do it on my own personal vehicle not how everyone else should do it on there's. How I did it here is the quickest and easiest way for my vehicle. Can you tell me how it has lots of repetition? Each step is listed and shown from how to remove the filter to how removing it off the housing then installing it back into the vehicle. I'm sorry you can't recommend this video. With 7,100 views and 24 likes, this is the first negative comment I've received on this particular video. Thanks for watching and be sure to like & subscribe👍