How To Replace The Dome Lights on a 1999-2004 Jeep Grand Cherokee

[@Skillpont]

What's the brand of the lightbulbs? Any link?

[@Motorcycle_Man]

Lasfit bulbs, you can get them on Amazon or Ebay

[@Motorcycle_Man]

Limited-time deal: LASFIT 194 168 2825 W5W LED Bulb White Canbus Error Free, T10 LED Bulbs 400LM 6000K Super Bright for Dome Map License Plate Trunk Cargo Lights (2-Pack) a.co/d/bFX1otA

[@Motorcycle_Man]

Here's the Amazon link

[@Skillpont]

thx!@@Motorcycle_Man

[@tommythompson3422]

I have the same console with the passenger side light sticking. I figure it to be the plunger switch on the other end of the bulb connection. Is there a replacement for that? I was originally thinking the lens cover was the issue, but now I feel that switch is the issue.

[@Motorcycle_Man]

Question, have you pulled the assembly down yet to verify? I remember fixing one of mine with that same issue but I can't quite remember what I did since it's been so long ago. I can pull mine down tomorrow and see if that switch is replaceable. Because it most likely wouldn't be the lens cover only

[@tommythompson3422]

I have pulled it down. The bulb connection wiring loops around to the side of the lens into what looks like the plunger that activates the on/off for the bulb. I'm not sure the plunger is removable, but probably is. You can see the plunger when you look through openings in the area surrounging the bulb. A simple push on the lens makes contact with it. EDIT I went back to take a further look, and the bulb connection is a wiring harness that connects both bulbs from a central point. I've found that the housing for the plunger on the faulty light is slightly damaged and a bit loose, which is probably causing the issue with the light. If I can somehow repair the housing I'll test that, otherwise I now know it a complete wiring harness for the bulbs that has to be replaced. Appreciate the response@@Motorcycle_Man

[@Motorcycle_Man]

@tommythompson3422 I'm glad you got it somewhat figured out. I remember now that I actually had to go to a junkyard and buy another assembly because those pieces aren't easily replaceable. What I think happened on mine before I became really familiar with it was that I tried to pry on the lens to get the bulb out instead of removing the whole assembly which messed it up, and therefore my lens was sticking like yours. Good Luck and don't hesitate to reach out if you have any more questions

[@tommythompson3422]

Thanks@@Motorcycle_Man

[@shilohstailey468]

What size screw is that

[@Motorcycle_Man]

Phillips head

[@asiabadd3731]

@@Motorcycle_Manthe Phillips head screw driver goes from sizes 0-4 is that a size 0?

[@Motorcycle_Man]

@asiabadd3731 i dnt think so , maybe a 2 size

[@mattone818]

😎👍