How to replace the front sprocket on the KTM 500 EXC

Replacing the front sprocket on my KTM 500 EXC.
This is part 3 of 3...
Part 1: replacing the rear sprocket
Part 2: replacing the chain
Part 3: replacing the front sprocket

[@mirektrial]

When tightening the sprocket, a torque of 60NM should be used - that's a lot, with such a short key you will probably not press such power, even while sitting on a motorcycle.

[@dadbosworth6838]

Keith you must clean the spine and lubricate with moly grease to stop it wearing out

[@fairudzb]

Hey Keith … thanks for the helpful videos. Just wanted to point out that the torque setting of 10Nm in this video may not be correct. I only found out after I had oil weeping from the sprocket area so I re-checked & found out that it should actually be 60Nm.

[@wv4life375]

Your channel is a gem.

[@keithjob]

Thanks!

[@heathpendlebury6133]

Hey mate, what ratios have u been running for adventure work now the 500?? Cheers

[@joegummow2069]

Love your videos great content. What rear tyre are you running there?

[@gregmiller2178]

Looks like a D606 130 90 18, also good for the 690 enduro.

[@keithjob]

Tick.

[@bungs1980]

Hey Kieth, My manual it calling for loctite 2701 but it is not available in Oz. What type of loctite are you using? Thanks Scott

[@keithjob]

The blue one, 243.

[@bungs1980]

@@keithjob thanks mate