How To Replace The Upper Control Arm 2008-2012 Honda Accord

How to diagnose front end noise & replace the upper control arm 2008-2012 Honda Accord
Here are some of the tools that jimthecarguy uses
www.amazon.com...
Due to factors beyond the control of jimthecarguy, it cannot guarantee against unauthorized modifications of this information,. jimthecarguy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. jimthecarguy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, chemicals, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of jimthecarguy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not jimthecarguy.

[@toenails.]

Great video on how to inspect front suspension. Thanks

[@staceysims7270]

I saw a video of a mechanic using an extension and I believe a swivel and they were able to get the bolts out without removing the struts…. (1Aauto)

[@scuba422123]

happy new year jim! changing the ball joint in that steel arm would leave it loose some would weld it the whole arm is the way to go

[@ChristianNordquist]

Thanks Jim, great video as always.

[@thomastommy1192]

Another great video thanks for sharing it. I hope you are having a blessed fun New Years Day.

[@frankdamore2370]

Always enjoy your videos, very informative and easy to follow. Thank you.

[@dannielsawulski1221]

Does the suspension need to be under load before tightening the upper control arm or the lower wishbone bolt? Im asking because of the bushing. Will it wear out prematurely ? I'm going to attempt this job strut and upper arm replacement. Thnx for the video Jim.

[@bbkmm1]

This is one of Honda's more bone headed designs where the weight of the car is constantly trying to pull the lower ball joint out of its socket. I've seen more than my fair share of Civics Accords with the front wheel folded into the fender on the side of the roads.

[@someusername121]

This is how all double wishbone suspensions are done. The alternative is MacPherson which is cheaper and doesn't control geometry as well.

[@joehyundaitech7961]

jim hi happy new year your description reads upper control arm should it be upper ball joint instead ?

[@petar443]

He changed the whole upper arm. I wonder if only the ball joint could be replaced on the control arm actually with ball joint servicing toolset on this model

[@FleetTech97]

@@petar443it is but it’s a pain and I wasn’t able to press it out. Whole control arm isn’t much more

[@staceysims7270]

@@petar443yes I’ve seen videos of it done.but I would inspect the bushings as well ,as it may be better to replace the whole control arm.They come with the ball joints pre installed 😊