How to Replace the washers in a Bait Pump | Fishing & Cooking | The Hook and The Cook

[@williamatta5935]

Hey Awesome video The Hook And The Cook Thanks for showing me how to change and fix my Yabbie Bait Pump

[@stevelord1343]

Thanks for the video

[@TheHookandTheCook]

Glad you enjoyed, hope it helps. Thanks.

[@ianphilip1562]

I just bought an Alvey pump and it says to lubricate washers before using it. Dumb question, but what’s the best way to do it?

[@TheHookandTheCook]

I wouldn`t put any oil on it as the sand will stick to that, the water will do the job I find. but look into that not shore on that. Thanks. Regards Scotty

[@ianphilip1562]

TheHookandTheCook this is what Alvey responded to me with… “Yes just means when you go to use the pump wet in the salt water and adjust the washer setting to suit. When finished flush out in fresh water and loosen the wing nut before storage. Thank you for your support.” You were right, thanks mate

[@radj4719]

Great video, can I use the standard washer kit in an alvey pump? The one with two steel washers and single rubber

[@TheHookandTheCook]

I guess so as long as the rubber washers are the right size, I have made them over the years from rubber thongs and they worked well. Thanks for tuning in, catch you every Friday on The Hook and The Cook. Regards Scotty & Paul

[@radj4719]

@@TheHookandTheCook thank for your reply appreciated

[@furyfromthesky5492]

Where can I get this KIT in the US?

[@stephenslideways9690]

Had some ABC play Matts lieing around the house grabbed the pump traced the circle at the end of the pump now I have 500 rubbers

[@TheHookandTheCook]

Nice one yes I have used old rubber thongs in the past, work fine. Thanks for tuning in, remember new clips every Friday. Regards Scotty & Paul