How to run the ED250 in SimRail

[@wovelscotch]

Getting a lot of comments about not being able to get the train moving again once stopped. They have updated the behavior of the ed250 a bit since I've released this video. Make sure the brake is completely released, then reset the throttle all the way back until there's an audible click, then reengage the throttle. It should start moving again.

[@azlanharun8647]

Thank you for this tutorial. I always come here whenever I am stuck during start up.

[@azlanhar]

Informative! Thank you. I've been searching for the battery box outside to start enable the battery but could not find any.😀

[@Blo0dyMustard]

Quick and concise. Great tutorial! 😃👍

[@auelmusic]

The tutorial i was looking for 👍🏻

[@yumpinyiminy963]

Very nice job. I purchased the software because I think it has great potential. (I'm also Polish but can't speak a word. 😳) Don't know if you have heard or played "Run8 train simulator v3". These developers should team up. Run8 has all the physics but not so great graphics. Same idea though. Really nice job! Thanks!

[@maksio-c7j]

Anyone know how to start the traun with the new update in 2024 cause they added new things and now this doesnt work

[@SilkyTechh]

great tuorial thabks.

[@Schweizerleague]

its nice but when i stop the train in katowice, i cant move it anymore :D i dont know why. i even started the train all again and still nothing

[@wovelscotch]

reset the throttle all the way back until it clicks then re-engage the throttle

[@Surfingnet]

hello, nice video :) is there a way to stop the train using only the cruise control ? like in the EN96, you just set the desired speed to 0 and wait for the train to stop and then you apply the brakes, parking brake, etc. Because in the ED250, whenever I set the desired speed to 0, the cruise control stops (and because throttle is not at 0 it starts to accelerate...). Thx :)

[@wovelscotch]

Nah, the cruise control disengages when you set it to 0. From my experience you can't use it like in the EN96 and you have to brake manually.

[@mordsithrahl]

How do you turn a switch clockwise or counter-clockwise, when the mouse is over it?

[@mordsithrahl]

OK I found that, but now I have a new problem. Once I stop the ED250 train I cannot get it moving again. Brakes are set to running, parking brake is off, but if I push the power level forward, it moves, but the train is not drawing any power. What am I doing wrong?

[@wovelscotch]

@@mordsithrahl I would need more info. Only thing i can think of is that it takes time for the pneumatic brakes to charge up, the train will not apply power to the motors until they've completely released

[@wovelscotch]

reset the throttle all the way back until it clicks then re-engage the throttle

[@alienx102]

​@@mordsithrahlHey buddy can u tell me the solution for your first problem bcz i am also not able to turn it clockwise after my mouse pointing on it?

[@holytrucker2153]

thanks for this video