How To Scrape A Metal Slash Cut For Carriage Homemade Lathe

[@brettirwin2]

Your work is incredible Mr. Rany.

[@mr.ranyhomemade2466]

Appreciation thanks, I knew it was hard work but no choice because I don't have the equipment to make it all. I will try my best.

[@4eloveg1]

Good day. I don’t understand where such confidence comes from that the profile pipes along which the rack is now rolling are even?

[@mr.ranyhomemade2466]

Thanks, it works very well but takes time

[@ÁREAJ27]

Olá meu amigo trabalho incrível, parabéns!!! Boa sorte com muito sucesso e saúde!!!

[@Logan1set]

Круто! Жду продолжения :)

[@GBWM_CNC]

I'm wondering how much weight will your lathe have at the finish. Everything looks quite heavy

[@mr.ranyhomemade2466]

Appreciation thanks, a total of all approximately 230kg because I got to experience my first lathe ready the metal I used is 10mm only when I used mill thick metal always shaking. So I have to work on everything accurately I knew it was really hard work because I don't have any tools and equipment. Thanks again

[@medshop2931]

Vary good job thank you

[@mr.ranyhomemade2466]

Thank you for reaching I do hope you like my hard work.

[@عمرمرخي-ط2ذ]

شكرا لك قص الحديد بطريقة مائلة صعب جدا

[@mr.ranyhomemade2466]

Thank you brother for the best time to watch my channel I will try my best to keep improving. Is not easy to do it by hand to find a way to contact between metal, everything I did look good but behind the scenes super crazy to scrap it. But happy with my results. I hope you enjoyed more videos.

[@عمرمرخي-ط2ذ]

@@mr.ranyhomemade2466 شكرا على الرد

[@cncrampage]

Nice videos

[@mr.ranyhomemade2466]

Thanks for your comment. I will try my best thank again

[@cicerogambiarra6324]

Boa noite amigo que trabalho de fisio parabéns que Deus abusou

[@mr.ranyhomemade2466]

Thank you for reaching I do hope you like my hard work.

[@1crazypj]

Instead of saying slash cut metal, it's probably easier to say bevel edge for what will become the dovetails

[@mr.ranyhomemade2466]

Thanks for your patience and introduction me, I made it but I’m not sure how to call because is not my job and learn without book or have training before everything I did apart of my Diy. Thanks

[@bintangkecil6499]

Berapa tebal flat yang anda gunakan pak...