How To Service A 2004-2006 Marzocchi Bomber Junior T

Ignore this: Rebuild Service Disassembly Assembly Fix Restore Regrease Repair Refurbish Overhaul Clean
Use code “retrorev” for 10% off SRP products!! (except for tires)
Seal Kit:
specialtyretro...
Preload knobs:
specialtyretro...

[@getsomemtb7427]

Really well done instructions. Top notch. My set is 2003. If I can't find a more specific to my year, this should work well. 🍺

[@ejeje641]

2:04 Regarding the socket. I got a mini set that fitted no need to grind it down. But i had to drill the socket out inside so the rebound nipple could pass to fit the nut , on the left fork. A diamond tip drill bit for tiles went through the tool steel easy.

[@maxdredi]

thanks for the instructions, I just bought the lower part of the shock and will replace it with the oil service according to your manual :)

[@ejeje641]

Omg I just stripped my bike down and I'm about to service this suspension. Thanks

[@LhDiy]

9:28 It's like you put the wrong type of oil seal in , and it is not tight like it should. I hope there are no leaks ?

[@RetroRebuilds]

The fork works perfectly fine not sure what you mean

[@LhDiy]

@@RetroRebuilds The oil seal in your video has the spring on the upper side, normally this is only viewable by the underside. perhaps you put another type of seal ?

[@RetroRebuilds]

Oh yeah that was an older NOS seal kit those must’ve been different

[@joseperzolea1436]

sabras cuanto aceite utiliza por barra la Marzocchi Drop Off Triple ???

[@slideman.]

interesting! Thanks. I've never seen the insides of one of these. good job! (BTW, that is called a "set screw") 😉

[@RetroRebuilds]

Thanks lol I forget the names of stuff sometimes

[@slideman.]

I know. It's hard to do those videos while working and trying to narrate everything accurately at the same time. You're doing a good job describing the procedure and that's what's important! besides those screws have a million names (set screws, grab screws, pinch screws....depending where you're from... 🙂 )

[@burgerzz09s51]

I got this fork but it is way too soft for me now. You know how i could get new springs?

[@maciejfreeride]

i need some too

[@Lord_Marco]

You put the washer under the pre-load sleeve during reassembly, should go at the top, otherwise you won't be able to set the preload, as the pre-load adjuster is narrower than the plastic sleeve. And it appears that you are missing one of the white piston rings on a rebound rod.