How To Set-up Feed Mode in Fusion EP 19: Apex Aquarium Controllers from Neptune Systems

[@JahrTurchan]

BRS rocks!! Thanks for putting out so much great content. Definitely my initial go to source for info and recommendations.

[@nevadagunbros]

These apex videos are great! This one helped out a bunch, Thanks

[@sesopenko]

Thanks for the tip on where to change the feed interval, I wasn't able to find it on my own. I now have all my pumps set up on Feed A with the regular 5 minutes and I set up Feed B especially for water changes with a 60 minute time-out. All of the in-tank pumps that will run dry during the water change turn off for Feed B, which I initiate when doing a water change. It should make everything much easier!

[@kennmac4914]

I use feed C for when I’m broadcast feeding my corals. I would like the power heads to come back on about 5-10 after this feed mode is selected. The way I have them set up is during the hour of feeding they are set as low as possible. How would I do that if possible?

[@imghaniff]

I have a question about feed mode. I have got the equipment to shut off and turn on after the defined time. How do i have the apex play music before the pumps turn back on as an indication?

[@jordanperks326]

I use feed me to turn of each and every pump to include power heads so I can target feed coral.

[@SaltyReefTV]

im trying to figure out how to use the AFS to delay feeding 5 mins after the return pump has shut off when using feed mode. thoughts?

[@SaltyReefTV]

***** radical. i actually submitted a support ticket and they just built the code for my exact scenario. top-notch service i'd say!

[@CopperStateGoldens]

SaltyReefTV Can you share the code? I am looking to do the same thing , thx

[@SaltyReefTV]

Copper State Goldens Sure. So the code for the AFS itself I am using is: Set OFF If Outlet vFeedA_P1 = ON Then ON Defer 05:00 Then ON The virtual outlet code is: Set OFF If Time 14:00 to 14:14 Then ON If Time 15:25 to 15:39 Then ON If Time 16:50 to 17:04 Then ON If Time 18:15 to 18:29 Then ON If Time 19:40 to 19:54 Then ON If FeedA 000 Then ON If FeedB 000 Then ON If FeedC 000 Then ON If FeedD 000 Then ON

[@SaltyReefTV]

Copper State Goldens Pump and Skimmer: Fallback ON Set ON If Outlet vFeedA_P1 = ON Then OFF

[@jaredjohnson4556]

I want to be able to have my COR 20 go to 5% and not fully shut off so I don’t have to worry about bubbles when coming out of feed mode. Is there a way to simply dial back % Power of COR20 during feed mode rather than shutting down completely?

[@jsauce666]

So when is Fusion releasing?