How To Set Up Salomon Hologram Binding

[@eftihiosgalanis6977]

Thanks for the video, just got myself some Salomon bindings and was not sure if I needed to use the little white plastic it came with to hold the screws in place

[@owenill4884]

Did you use them?

[@eftihiosgalanis6977]

@@owenill4884 yes. You’re suppose to leave them on. It helps with setting them up

[@GamingPlusTV1]

Keep up the quality content, great channel. Liked 7

[@mjg4936]

Thx for the video! I have the exact same board and bindings! Just got them!

[@ky.tremmy]

Beautiful board!!😍😍

[@gtech5884]

Using the toe strap to the cover down! omg i never thought of that

[@georgeshaw5959]

Do you leave the white plastic guide in when you install the bindings?

[@notretou]

I think he kept it.

[@botbot3000000]

Yes it is meant to stay in

[@JJ-nm8sh]

and nothing about extending that toe ramp to cater for that massive overhand of the boot over the binding - yep, will DEFINITELY come to you guys to help setup my kit 😆

[@sonnysnowboardingchannel5308]

Sorry . maybe is my video editing missing some fragment , this my first time editing I hope you understand even KZbin AI translation can be mess up -yes ,you can still use KZbin AI translation😂

[@sonnysnowboardingchannel5308]

KZbin AI subtitle translation

[@turnleft5876]

加油朋友

[@ish7926]

Which size are the boots and the blinders?

[@sonnysnowboardingchannel5308]

depends on your boots size to Measurement your Binding

[@Existinginthespace]

Don't forget to adjust the forward lean on your bindings. On the hologram, it's the very bottom screws on the heels. Educational bindings video kzbin.info/www/bejne/jamrgWifiK-Kq68

[@georgeshaw5959]

Anyone know if these bindings fit the 3D hole pattern on old Burton boards?

[@sonnysnowboardingchannel5308]

I don't know how KZbin AI Subtitle translation mess up like this 😅

[@sonnysnowboardingchannel5308]

please don't use KZbin AI translation watch this video

[@wanqiguo5059]

一起约滑吗嘿嘿😁

[@anais4766]

😓talked about everything I already know except how to adjust high back forward lean which I couldn't figure out...

[@wanqiguo5059]

埃德蒙顿？

[@sonnysnowboardingchannel5308]

对的

[@botbot3000000]

You have probably figured out already but if anyone else reads you need to loosen the screw on each side near the ankle and then slide those screws either way which will adjust the lean then tighten the screws