How to set up your RPM Gauges and LIGHTS using the Lund nGauge

A little quick demo of how to set up your RPM gauge reading. Make sure the car is running so you can see the RPM levels moving.
Also in here shows you how to change your RPM/Shift lights

[@alex_5sl09]

Can you post a Video how to use the Afr with the lights ?

[@bybcous]

will this raise roms for launching or just shift light's?

[@Twobarpsi]

Great video! Can you set the shift lights up, in this manner (as an example)? I would start the first light at 5500 the next 5700 ..... 5800...5900....6100....6200 ? That way you get a nice progressive warning as you get closer to redline. Then when you see the first red light, you know its time to shift!

[@chxpo8776]

My ngauge always turns off after like 30 seconds why is that? I always have to tap the screen to keep it on

[@jhonathanspencer8216]

This was very helpful. Thanks!

[@dant.2204]

What mount is that?

[@Jbrad9]

I tried to select rpm on multiple led section and it only had zrpm which didn't show my rpms

[@Johndnardi07]

ZRPM is not the correct readout if this is not using a Zeitronix wideband. Please email us at [e-mail] so I can better support this . Seems you are on the wrong gauges

[@harleyjaque6275]

Where did you get that gauge cluster from??

[@Johndnardi07]

Had it dipped