003 is absolutely correct, my predator runs great.
@julianbailey99342 ай бұрын
Thanks man. Finally I know how to do that
@kenmorrisproducer26 күн бұрын
How much side-to-side movement is acceptable? Pulled the valve cover on my GX200 and the intake rocker has some play left to right (like yours in the video) by my exhaust rocker is really really tight. No play. Both move freely and the engine runs fine. Noticed some sputtering at WOT though.
@MesaMinis26 күн бұрын
honestly stock rockers have a lot of play. sputtering is from your carb try a bigger main jet or add more fuel to the fix
@kristianstaton66969 ай бұрын
Thank you I was needing the valve lash specs. Y'all are in AZ?
@MesaMinis6 ай бұрын
Yes we are
@robertluich56563 ай бұрын
You just want a little bit of resistance when you use the filler gauge
@modernmountaineerАй бұрын
The manual says .004-.006 intake and .006-.008. Have you tried 5 intake and 7 exhaust?
@MesaMinisАй бұрын
Never Always .0003
@sweidiorАй бұрын
@@MesaMinis great vid i also have question sorry lol i just put a arc billet flywheel on gov deleted predator 212 hemi nd i could start it find by pulling start cord nvr any snap backs until i installed the billet nd i set them both at .003 what can i do to get rid of the snapping back of the pull cord ?
@maxagathos5 ай бұрын
hey bro, what size mm is that nibbi? i’ve been struggling to find one for my 24mm nibbi.. thanks
@collinherrmann-yt8yh Жыл бұрын
lemme get in on ts fr got an all billet 224
@MesaMinis6 ай бұрын
What is Ts
@korbin____44194 ай бұрын
❤️ur a beautiful person
@Hoodadventures602 Жыл бұрын
Sick
@fatpinksherbert23 күн бұрын
Hey can anyone help me i have a non hemi the guy i got it from kids ran it on choke for like an hour could it be broke valve cleaned carb checked fuel flow adjusted the valves it still runs like shit thanks
@MesaMinis23 күн бұрын
Most likely the carb tune
@kegancovey21695 ай бұрын
I don’t understand the locking but part of this. I’ve been sitting here messing with my valves for like 3 hours and both nuts are adjusting the tightness it’s impossible to get it snug. Please help lol
@kegancovey21695 ай бұрын
I’m timing them at .003 and no matter what I do it’s either too tight where I’m ripping my feeler gauge out or it’s way too loose.
@jfgrovier27382 ай бұрын
@kegancovey2169 you tighten the big nut with your fingers.
@justconcentratee26 күн бұрын
Tighten bolt finger tight onto the feeler gage. Then slightly loosen bolt when also tightening the 10mm nut
@HoeLeeFuQQ4 ай бұрын
Will a credit card work?
@buyerenogurlfwendo21063 ай бұрын
Bro the feeler gauge set is like $5 at harbor freight 😂