how to setup dtk delta pid temperature regulator

dtk delta pid regulator
heating element 300 w 220 v
fotek solid state relay
K type temperature sensor
---------About---------
This Channel was created to share knowledge and experience in engineering, sole purpose is to encourage makers , making even more stuff.
---------*Follow me for updates*---------
► Patreon: patreon.com/nikaalika
►Grabcad: grabcad.com/ni...
►Instagram: / alavidze.nika
►Facebook: / 1nikaalavidze
►Behance: www.behance.ne...
►Twitter: / allprojectm
►instructables: www.instructab...
-----------WARNING-----------
My channel takes no liability for property damage or injury caused as a result of any of the information contained in this video. ---- recommends safe practices when working with power tools, lifting tools, automated machines, electrical equipment, blunt instruments, chemicals, expensive electronics, equipment or any device implied in this video. Everything you do is under your responsibility so please take care. Measure twice and cut once.
-----------GEAR-----------
Video was shot on canon 7d and Galaxy s9. For Audio recordings sometimes I use integrated microphones or Sennheiser g3 and Rode NT usb mic.
Thanks all for the support =)
#diy #nikaalavidze #engineering

[@naengineer]

do not forget, some dtk pid temperature controllers have directly 12 v output signal to control solid relay some have relay output, just read through user manual or you can see information on the side of the controller