How to setup Limit Switches of Limitorque MX Actuator?

[@MrRamsfan0315]

I have a question after the limit stops have been set, I noticed I had trouble with a timeout torque alarm. The valve opens very slowly 2pct at a time when it should normally respond at a 10 to 12 pct . How do I resolve this issue? Thanks.

[@eddtmz1773]

Awsome vid thanks

[@merlissoto3923]

Very useful...!!!!

[@كاظمالمؤمن]

If it’s 24vdc is required?

[@79series]

What happens if the firmware doesn't reload the settings when flicking to local and stays at set close position.

[@jitubabusay2826]

very helpfully

[@harryfelix5253]

Can anyone tell me why there is a hand lever on it? Is it for locking?

[@ابوساري-ب8غ]

Valve jammed alarm alawys coming without mechanical problems. Why?

[@mikolaistv2465]

Is for latching and unlatching if wantt to manual close or open valve.

[@boostyourbrain345]

Tq so much

[@venkatvenkatesh3235]

R u using limitorque actuator?

[@Suveshdatt]

Chow to reset hardware failure alarm

[@mariolourenco7810]

bom video

[@ghazibagazi9687]

Sir What about overtourque settings? My acuqater when close it got overtourque and i have to put it to local then open then returned it back to remote to get ok and cleat the overtourque?

[@dsookoo4204]

Not getting feedback milliamp to return to dcs

[@johnwyatt27]

Sounds like a problem on there end check there fuses?

[@nageshwarkashyap9906]

s1 s2 not coming in mov than what aer duing kn mov