Can't wait to try this with my intake. Thank you for the video
@nowayyyhoseАй бұрын
Im goint to try that on my intake. I hope that makes it lower so i dont have to cut the back of my stock hood
@cliff_hatch3rАй бұрын
@nowayyyhose go for it! it doesn't really make it a lot lower tho. Maybe a quarter inch. It's mainly for looks if anything
@nowayyyhoseАй бұрын
@@cliff_hatch3r a quarter inch is a quarter inch lol
@cliff_hatch3rАй бұрын
@nowayyyhose you ain't wrong 😂
@nowayyyhoseАй бұрын
@cliff_hatch3r I was asking for, I have a anderson compsite type tt hood and it's stock clearance. I didn't wanted to cut the back of the hood or lower the engine. Hopefully smoothing it prevents the hood cutting.
@cliff_hatch3rАй бұрын
@nowayyyhose what year car? I didn't know there was hood clearance on aftermarket hoods with the boss intake. This went on a 13/14 Mustang with a cowl hood
@brianpreston29117 ай бұрын
Just got my boss 302 Intake. How do I take the top off without damaging it. The Part your gonna grind down. Don't wanna screw up my project.
@cliff_hatch3r7 ай бұрын
Just take a plastic pry tool and pry up on it until the double side tape turns loose. Do it slowly and as evenly as you can. That's all that's holding it
@brianpreston29117 ай бұрын
@cliff_hatch3r thank you sir.
@cliff_hatch3r7 ай бұрын
@@brianpreston2911 np. Let me know if you need anything else
@brianpreston29117 ай бұрын
@cliff_hatch3r thank you sir. Can't wait. I'll post a video when done
@brianpreston29113 ай бұрын
@cliff_hatch3r hi sir. Excited to do this job finally. Been busy.
@high-rise8505 Жыл бұрын
Very nice! 🇺🇸
@brianpreston291111 ай бұрын
What tools did you use for this. Getting the ported and polished boss 302 intake
@cliff_hatch3r11 ай бұрын
I showed everything I used in the video.
@brianpreston291111 ай бұрын
@@cliff_hatch3r I wanna buy the same tool. Don't know what model it is. Thank you.
@cliff_hatch3r11 ай бұрын
My bad, man. I didn't think about listing the actual tools I used.
@brianpreston291111 ай бұрын
@cliff_hatch3r it's ok. I'm a disabled vet building my daughter a show car. 2014 mustang gt. Wanna spice up the engine bay. Never done anything like this. Wanna buy the right tools ect.
@brianpreston291111 ай бұрын
@cliff_hatch3r when done ill post a video of my ported boss 302 intake
@Mountain-Man-3000 Жыл бұрын
Just get one 3d printed.... Any shape you want!
@cliff_hatch3r Жыл бұрын
I wish I knew someone with a 3d printer. It would definitely have made my life a lot easier