I m not native english speaker ,but Hhope this can help you . thank you . If it did , may I get a like 👍?
Пікірлер: 12
@razpv53465 ай бұрын
THANK YOU! 5 hours into trying to update my AIO and ran across your video, disconnected my ELRS receiver and all was good! 🎉
@AnžeMerhar Жыл бұрын
You my good Sir are my hero! I have been banging my head with my FC for a few days with no solution working. But when I unplugged everything, I could update my firmware with ease. Thank YOU!
@xXDanielSilva559Xx6 ай бұрын
Bro I had this issue with my YSIDO flight controller and it was because the GPS what hooked up to it. I tried to disconnect the ESC and that didnt work but as soon as I disconnected the GPS, Impulse RC found it and fixed the DFU drivers. Thanks bro so damn much.
@Marvin_McFly9 ай бұрын
Thanks dude this worked in INAV 7 trying to update a speedybee F405 wing board to V7.0 from 6. its a stack and after remving from the bottom ESC board it worked.
@CineUAV-FPV-Drone-Videographer Жыл бұрын
Thanks! By your video I was able to get into bootloader and flash betaflight again. Good job, thx for sharing =)
@olegpipikin33366 ай бұрын
Thanks a lot. Your solution really helped me. But in my case I had a GPS, connected to FC, and it didn't allow to connect to FC in DFU mode.
@LEO_FLY4JOY6 ай бұрын
unplug it or desolder it temporarily
@lonsark7 ай бұрын
How to be with aio?
@bcc1955 Жыл бұрын
Instead of desoldering simply type "BL" into CLI and hit enter. This will disconnect and put you into DFU mode. Then proceed with your firmware flash.
@asket13c Жыл бұрын
Could you pls explain more in detail?
@RekkePukka4 ай бұрын
Just turn off the radio.. and try to put it on dfu.. it will...