i am looking to trim a kids 'space' themed bed, it is the untrained attempting the impossible a little..., I have a spray gun and compressor (2.0mm HVLP Gravity Feed Air Spray) and looking to spray the DAP Products Weldwoodvia this . what pressure should I run and what pattern spray is acceptable (or what to avoid?)
@coastalcushionco8227 Жыл бұрын
there is no hard and fast rule when it comes to spraying glue . you will have to do a test spray. What you are looking for is an even spray. on large areas you can use a wide fan pattern to get good coverage, but on smaller areas use a smaller fan with a bit less volume of glue but a slightly higher pressure
@itolond Жыл бұрын
@@coastalcushionco8227 thankyou - ill give it a go
@itolond Жыл бұрын
Also what type of plastic sheet are you using for your templates (thickness type?) - I attempted to see some plastic drop sheet but it seemed too weak and pulled araprt
@coastalcushionco8227 Жыл бұрын
Its a patterning plastic called PE Fibretex Clear 205cm supplied bywww.kayospruce.com
@itolond Жыл бұрын
can you staple GRP panels (3mm thick?) if not just glue?
@coastalcushionco8227 Жыл бұрын
GRP is to hard for staples they will just bend, what material are you glueing to the GRP
@itolond Жыл бұрын
@@coastalcushionco8227 pu /vinyl
@coastalcushionco8227 Жыл бұрын
@@itolond Vinyl is not easy to glue to GRP you have to use a very specific glue. I explain about gluing vinyl in my Best Range Rover Classic interior upgrade video.