How to test DC motor or Treadmill Motor?

i made a detailed video on this..
i hope you would like it.
for any queries contact us at:
[phone]

[@jaseralomary8854]

Dear brother many thanks

[@Techlabfitness]

W

[@Techlabfitness]

Wc brother

[@chandrushekarshekar7032]

Thank you so much sir good information

[@Techlabfitness]

Wc

[@sparkigner908]

What is rectifer current rating

[@volcanicmind111]

Hi Sir, thanx for the video. Do you have the Schematics for the control board Model B204 S11 for JADA Tred mill

[@Techlabfitness]

Sorry we dont have

[@bibbidi_bobbidi_boob]

How to reduce high pitched whine as rotational speed and load increase? Does it indicate a failing brush to commutator or over heated coil wrap? Small section of each commutator contact glazed. Even if cleaned off still makes the loud noise. Please and thank you!

[@Techlabfitness]

Hey brother.. I didnt get your point?

[@24ilyaas]

Sir can i put 40w bulb

[@Techlabfitness]

No

[@nateshkumar7965]

how to fix the issue, if magnet is too week..

[@Techlabfitness]

Which magnet? Motor or safety key or speed sensor

[@nateshkumar7965]

Dc Motor magnet

[@Techlabfitness]

@nateshkumar7965 motor magnet weak issue dont have any authentic solution.you have to change the motor

[@nateshkumar7965]

Motor two wires connected to the multimeter. Spinning the rotor by hand. I am getting 4v max.. But if I give DC voltage .it is rotating.. Am not getting clear view on this.

[@sardarzeeshan88]

Brother mane treadmill ke motor ko 12v ky adaptor sy ar battery sy check kia pr wo halka sa move hoti hai ar ruk jti hsi. To kia moter khrb hai ya koi msla hai?

[@Techlabfitness]

Yes

[@harpalsingh-js8tz]

Hi sir, can you please provide MOSFET number for 2hp dc treadmill motor?

[@Techlabfitness]

Irfp 460 G40N60

[@kamalbagdad388]

Pls can this connection works for 24 hours

[@Techlabfitness]

Hi..i didnt got you

[@PHM_Tech]

Yes

[@muzamilhussain-qf8wm]

A aaa aa aa is irritating 😔

[@davidhoward5586]

This guys hides everything and his connections are very suspect as in his solder joints and power through a clip boot to the relay or mosfet. Needs to show what he is doing and not have everyone burn their motors out.

[@Techlabfitness]

Please mention where i have hided something