How to Use a Hunter Pro-C Irrigation Controller | Full Walkthrough & Operating Tutorial

[@kittenkorleone2918]

Thank you! Thank you! Thank you! Clear instructions.

[@derrickmitchell39dm]

Excellent tutorial. Thank you.

[@DM-bx1zv]

Excellent video! Exactly what I needed.

[@brockmangroup9404]

Can you do a video explaining how to wire the system up to your sprinkler heads?

[@Meatball2022]

Will it run all programs all the time? Prg a b c and d? Or is it one program at a time?

[@markscott5514]

Ok great thanks ..why when the power goes out it reverts to hrs of watering? I mean hrs wow kinda extreme.. How do I fix that ?

[@MegaBpop]

Thank You for explaining the PRG button. A diff guy in a diff video was not as thorough as you

[@painkillerO8]

That is the exact controller I have.

[@gooblesnork]

For the watering I have "A" setup for daily, for "B" somehow I have it on intervals and for the life of me I cannot figure out how to shut off this feature. Any suggestions? My controller is an older model so I do not have the two up/down buttons on the left of the screen. Everything else is the same

[@DanielDaly-y8b]

lost station #4 had all 4 this morning now it only goes to station 3 and stops

[@normankoelling711]

I have a Hunter Pro C late model, I had to change one of my control valves. After I changed the control valve my Pro C does not recognize zones 5or 6. When I go to program the controller to goes from zone 4 to zone one even though it is not time for zone 1 to turn on.I can turn any of the zone on by doing it with the single zone on the controller.

[@realturfsolutions8991]

Make sure your modules are properly installed in the controller so that it is set up for those zones. Then also be sure that the zones have run time set for them, since it will skip over zones sometimes if you don't have any time on them. If that doesn't fix it, you'll probably need to call your local irrigation service to come take a look at it. They'll be able to get a better idea being able to see it and all.

[@johngraceffa1762]

My seasonal adjustment constantly changes from 100% which is set point. Changes to 30,40,60% on its own. Why???

[@simplekass8749]

how do i know which are what stations!?

[@joanryan-et2bl]

After the system ran , it started up running again. What happened

[@stephencao8416]

I wanna take care of my lawn by myself, this one will definitely not be an option. No app! How can I do remote control, how can I monitor it while away from home? Would go with ImoLaza that kind, designed for homeowners not contractors.

[@thegreengiant777]

How can I lift the sprinklers up out the ground to change them

[@realturfsolutions8991]

If you are talking about rotor heads, you will need an irrigation head adjustment tool. Look at the top of the sprinkler head and you'll find two circle shaped slots, these are for adjusting the rotation and spray range. There should be a third little slot that looks like a line with a round part in the center of it and usually covered by a rubber flap. This is the one you want. If you push the top of the tool (the plastic handle end) into this slot, you can pull up with the tool and raise the head. you'll need to grab it with your hand to hold it there. To change out the entire head assembly though, you'll likely need to actually dig it out so you can disconnect it.

[@roseknight9341]

Keep getting P err