Removing Components from Circuit Board | Soldering

Full Playlist: • How to Solder
-
-
Watch more How to Solder videos: www.howcast.com/videos/504736-...
We've learned about solder wick and solder sucker and now we're going to use these devices to remove components from the circuit board.
First we're going to remove this surface mount capacitor. So we're going to use our solder wick to remove the solder from one of the terminals of the device. To do so we've trimmed a fresh edge, we're going to apply a small amount of flux to the tip and we're going to place the wick between the device and the tip of our soldering iron and we're going to remove the flux beneath.
As we do so the solder flows into the wick and we've got a lot of solder here so we have to move it to several positions. Be sure that we get all the solder from beneath the device.
With one terminal removed we heat the other device and grasp with tweezers which allows us to remove the device without damaging it.

[@OkPickles]

Thank you this video was so helpful! I learned so much looking at a zoomed out shot of your face

[@dusanveselka3240]

isnt it annoying when they dont keep filming the actual work and interrupt it to film the workers face...

[@fourburnerbreakfast]

i know, it's not an effing movie

[@tunkunrunk]

@@fourburnerbreakfast what is effing ?

[@EVERY.CIRCUIT]

Very good

[@AlfredSpiteriarmy18270966]

Hi Like your video can you please tell me where you bought that board Vice Holder please thank you

[@mrtookyogirl6698]

The store

[@aurelvogli8562]

Hey can you remove a controller board from the motherboard?

[@AbrianaHeight]

What is the name and brand of the device you are using to hold the circuit board in place while you remove the component?

[@Affishul]

Helping hands

[@jackglossop4859]

Herman holdy helper

[@louiemares1610]

What if it has multiple connections I was able to remove all the top soldering but it still has enough to hold the circuit in place I can heat up one but the rest will not let it go out it has 8 on each side

[@mrtookyogirl6698]

Dude I just had the same issue. 4 GD points and you want me to just do this? Ha FU

[@thedillestpickle]

You have to remove all the solder using the wick.

[@shutdahellup69420]

how do i remove resistors and capacitors they are soldered and wire is bend at the end(grabing the circuit board if you know what i mean!)?

[@thedillestpickle]

You have to get rid of all the solder holding the wire first using the wick. Then grab with pliers and bend straight.

[@wessdayy]

ZOOM INNNNNN!!!!

[@isaaclol1626]

FIRST! , uhm.... uh.... POTATO!

[@TonyFisherPuzzles]

It's called solder not sodder

[@PraveenVenkateshAwesomeroks]

+Tony Fisher pronounced sodder, spelt solder.

[@kratu6625]

+Praveen Venkatesh it's not pronounced "sodder'' you imbecile.

[@PraveenVenkateshAwesomeroks]

Bye 😂

[@TonyFisherPuzzles]

YTRKS Very true. If I had said "sodder" at school my teachers would have called me an idiot and my class mates would have taken the piss.

[@PraveenVenkateshAwesomeroks]

Btw Im a Cuber! :P

[@jcdijan6396]

great content ruined by bad editing/filming 😒