Hughes 500D Freeware Realism Enhancement Mod - X-Plane

  Рет қаралды 9,069

Sim VRlabs

Sim VRlabs

Күн бұрын

Пікірлер: 27
@piloto_loco
@piloto_loco 3 жыл бұрын
i have 2 questions please: - why is this helo overheating during every flight? takes about 10 minutes and it would spit flames out of the engine. - is there a way i can get the original tab back instead of the ipad? thank you so much for your work.
@ChadRyan
@ChadRyan 5 жыл бұрын
Awesome! Nice work!
@JohnDGregory
@JohnDGregory 5 жыл бұрын
It looks like you have done a fantastic job with this. Looking forward tto the release.
@Jax0319
@Jax0319 Жыл бұрын
Man where can i get this? Nice video thanknyou. Also possible to add pod/weapons?
@nukenabber7228
@nukenabber7228 4 жыл бұрын
Very nice simulation.....when to use the fuel pump (cooling it down without igition on?)
@mja206
@mja206 4 жыл бұрын
N1 relates to engine compressor speed which draws air into the engine, this keeps the TOT down during light off not the fuel which is why low N1 causes hot start.
@pickle4474
@pickle4474 2 жыл бұрын
Great heli, unsure what I doing wrong but after a few minutes of flight all the warning lights go off and I have no engine. I know it's probably something I'm not doing right.
@belgeode
@belgeode 5 жыл бұрын
Brilliant sir! Let me know the moment this is available please.
@Hugmyparachute
@Hugmyparachute 3 жыл бұрын
What do you use to record this video while in VR ? My VR looks all skewed on the monitor but immaculate while under the hood . I’d like to share some of my flying with friends. The video but the quality looks nothing like the real thing while in VR .. thanks
@cpt.mukhwasi
@cpt.mukhwasi 3 жыл бұрын
Great video...….need help mine the doors aren't showing up but in the livery there is
@Morrov
@Morrov 5 жыл бұрын
Amazing work
@flybe146
@flybe146 5 жыл бұрын
This looks amazing, can't wait to try this. Is there any way I can make the Oculus touch controllers less sensitive when it comes to turning switches in any cockpit?
@MrMo-gr5ob
@MrMo-gr5ob 5 жыл бұрын
Thanks Joe! 😊🍺
@Visser2800
@Visser2800 4 жыл бұрын
Waw, your an expert. Nice job.
@Arkaine_
@Arkaine_ 4 жыл бұрын
Curious question; in case of a hotstart, what would be the procedures to clear it ?
@Jonay1990
@Jonay1990 4 жыл бұрын
fuel shut off immediately, and leave the starter running to blow out as much of the gas as possible. Then refer to the POH (Pilot's Operating Handbook) for the aircraft and it will tell you if you are allowed to attempt to restart it (after allowing it to cool down over a set period) or if it cannot be used and the engine is then in the hands of the engineers to determine if you've melted the combustion chamber and needs replacing or if its ok to go again., Don't be that guy that writes off an engine for not paying attention and trying to restart the turbine too soon after the last run and not letting the residual heat dissipate sufficiently...
@ellonysman
@ellonysman 5 жыл бұрын
Youve done such a good job on this MD500 that I think youve killed poor DreamFoils interest in the same. I would have both.
@chrisgard4076
@chrisgard4076 5 жыл бұрын
how do i 1) assign the idle throttle and 2) assign lever for the rotor brake please.... great vid
@GAFflyer
@GAFflyer 5 жыл бұрын
get to your control settings, look for the button you want to assign and click "custom" on it. In the following menu type "500" in the search bar. It should list all the available commands for the chopper. Select IdleStop Ring Release, hit Apply. Not sure if you can map the Rotor brake though
@smjj08
@smjj08 4 жыл бұрын
love this helicopter, great job. I can't seem to get it to keep from sliding all over before starting, and can't find anywhere someone else had the problem. Any help would be appreciated.
@simvrlabs908
@simvrlabs908 4 жыл бұрын
In your general x-plane settings, bump your "flight models per frame" up to 4. That will fix you up.
@zexky5954
@zexky5954 3 жыл бұрын
scenery pls
@jasonreed2190
@jasonreed2190 5 жыл бұрын
THis is amazing.
@ASuperiorKiwi
@ASuperiorKiwi 5 жыл бұрын
Could you please help... I do everything you say to start it but the rotor wont start spinning? the rpm won't spin up. Thanks
@simvrlabs908
@simvrlabs908 5 жыл бұрын
Probably your rotor brake is on. It's behind you, over your right shoulder...black handle.
@TheRyma52
@TheRyma52 4 жыл бұрын
The helicopter Hughes 500D by Brett S. is totally overrated. This helicopter is the only helicopter pinned in the X-Plane forum, although there are other helicopters which have a much higher download rate. I know the reason: Because Brett S. is the moderator of this forum and he wants to push his own helicopter. By far the best freeware helicopter Bell 429 from timber61 with 120'000 downloads is not pinned, the Hughes 500D has only 23'600 downloads.
@FreeFire-kg6rs
@FreeFire-kg6rs 3 жыл бұрын
সালা
HeliTrim - Flying X-Plane Helicopters with basic controls
28:43
Reflected Reality Simulations
Рет қаралды 10 М.
Freeware Gems - The MD500D by Brett Sumpter
21:04
The Nerdy Heli Simmer
Рет қаралды 2,1 М.
УНО Реверс в Амонг Ас : игра на выбывание
0:19
Фани Хани
Рет қаралды 1,3 МЛН
Xplane 11 Bell 412 Start, Flight, and Shutdown
15:49
Up In The Sky Canada
Рет қаралды 300
Evolving AIs - More Complex Environment
22:24
Pezzza's Work
Рет қаралды 128 М.
[X-plane 11] 17 Amazing Freeware Plugins for X-plane
11:21
Thomas Rasmussen
Рет қаралды 304 М.
Flying the MD500 Helicopter
14:28
AB Helicopters Ltd
Рет қаралды 81 М.
X-Plane 11.30 Cessna 172 S-Tec Autopilot Tutorial
24:50
Philipp Ringler
Рет қаралды 64 М.
X-PLANE 12 vs MSFS FLIGHT MODEL: I'M SHOCKED!
5:54
VR Flight Sim Guy
Рет қаралды 280 М.
Nimbus UH-1 for X-plane 11
7:55
Nimbus Simulation Studios
Рет қаралды 17 М.
Mini frietpan
9:22
Frietpan Frank
Рет қаралды 51 М.
УНО Реверс в Амонг Ас : игра на выбывание
0:19
Фани Хани
Рет қаралды 1,3 МЛН