Hurco Tool Setup and Calibration

[@XhectorX1417]

Broke tool at work, on a machine I've never used...this video was a life saver. Saved the day!

[@sam29-i3o]

I got my job as a CNC setter by watching this! Cheers bro

[@tonybruyns8514]

Hi there, a bit new at this conversational programming thing, I just bought a Hurco TM10, and greatly appreciate the additional instruction videos.

[@lewielovesbud]

Worked on hass machines for years then switched company’s now work with hurcos and all I can say is they are awesome so much easier to use and write programs on

[@fherrchiss]

thanks, Tom for remaind me in this video all I have learnd from you, at leed Himmel. I hope to see more all about the hurco and Winmax thank you.

[@kevinking2343]

good video, Tom, thanks! What is the "200" value used to set RPM and feedrate? and where is it derived? Also (most importantly) technically, what is the editable "zero calibration" value found in Tool Setup? Using a tool presetter, how does one enter the known length of tool while in conversational mode? many thanks!

[@mikeoliver198]

Thank you! Great job.

[@Inverted1100]

ATC keeps hitting spindle housing when doing a tool change. Just all of a sudden. Any idea what it could be?

[@dni3541]

That is 5 axis machine. You show us like work offset as 3 axis machine. Do you know how to setup G54 and G55 ?

[@MrRatniProfiter]

Thank you

[@project165]

Why do we Zero Cal to the part instead of to the machine table? Excuse the lack of knowledge

[@Zkkr429]

5 axis with no tool probe :'(

[@rababerdreng]

Josh Hanson