Out of the box my 572 whoops up on my 2 372 xp saws. It will soon surpass my 576 non auto tune in power. It is my new favorite saw. Wow!
@jeremystuber69374 жыл бұрын
I just bought the new 572xp with a 28" bar and a full house x-cut chain, the thing is nasty mean and I absolutely love it! 💯
@johnagen36884 жыл бұрын
Insane saw!! I love mine!! Was looking at 562 a bit also but glad I went 572!!!
@EshlemaniaTV4 жыл бұрын
A lot of times the choice between a 562XP or a 572XP just comes down to how often you will use the saw. If you're using it daily then the 572XP is worth the extra money.
@partscounterguys6505 жыл бұрын
This is a bad ass saw!!!
@derekemanuel25764 жыл бұрын
Thanks for the comparison. I'm trying to decide between the 562 or the 572. I think the 572 is bigger than I really need but it seems to be built better. Not sure that's worth the extra weight in an all around saw.
@johnagen36883 жыл бұрын
I was in the same boat before the 572 came out, glad I waited and went with 572. I just love it.
@shane41764 жыл бұрын
Inboard vs outboard clutch I would say the sprocket is still in the same line. I wouldn't think the outboard clutch on the 562 would make the saw thinner. The sprocket still needs to line up directly with the bar. Just my thoughts, great video very informative.
@EshlemaniaTV4 жыл бұрын
The sprocket does need to line up directly with the bar as you mentioned. And when you move the sprocket inward you also move the bar inward which moves the weight of the bar inward closer to the handle. It all ads up to make the saw a bit easier to maneuver and roll around for its size. The inboard clutch and slightly slanted cylinder to give clearance to a shorter front handle are some features that Husqvarna loves to point out because it helps to make bigger saws feel lighter since it takes less effort and arm travel to roll them.
@shane41764 жыл бұрын
@@EshlemaniaTV got it well thanks for the information!
@johnagen36883 жыл бұрын
Is there a usually a charge to update firmware? Haven't inquired about that yet? So never have had it done. She rips tho! Be running it tomorrow.
@EshlemaniaTV3 жыл бұрын
That really depends on the dealer. Some dealers charge for it, some do updates for free if the saw was bought from them or is in for service, and then there's a lot of others in between that. It doesn't take long to do on newer AutoTune saws so even if they charge it should not be much.
@warrendrew2427 Жыл бұрын
What’s is the most amount of hours you have seen out of the 572?
@christopherdavidson47064 жыл бұрын
My 562 ended a bad case of CAD.
@man91703 жыл бұрын
What happened?
@llyodmilward40453 жыл бұрын
Apparently the 572 is having issues with crank bearing failures due to poor QC