Husqvarna Automower Loop Signal Failure Fix

[@marcuspedersen1749]

im gonna go MAD, ive tryed this and a bunch of different trubbleshooting tricks including resetting my mower to factory settings, but i can't seem to find anything wrong with the cables or the conections, the only guess is that i have to many connections (places where it has broken) maybe to mutch resistance in the wire

[@peterjensen2873]

Hej Marcus. Fandt du en løsning?

[@marcuspedersen1749]

@@peterjensen2873 had to replace a big section of wire where there was alot of "connections" (almost the whole cable) and that did the trick

[@peterjensen2873]

@@marcuspedersen1749 Ok. Tak hurtig tilbagemelding.

[@peterjensen2873]

@@marcuspedersen1749 Gravede du det gamle tråd op?

[@EWollan]

@@marcuspedersen1749 I'm thinking I have the same issue... I actually get continuous signal using a measurement tool (connecting both AR and AL to i.e a multimeter). And I can confirm the same using one of those radio tools as well as I get a signal at various intervals all around the property. I also did the trick where I only leave the AR connected to the station, and then I try to apply the G1 and G2 to the AL connector so that I can 'triangulate' which area is faulty (all were green which means I guess it's the last third section that is seeing more resistance due to many repairs...).

[@gilbert643]

Try with an underground cable, it's anaother story.

[@antonialikeshow3733]

Thank you !!!