Husqvarna String Trimmer Starter Pawl Replacement

[@grammo8]

I was really struggling to remove this! That was a solution I would never have figured out on my own, thank you so much!

[@repairclinic]

You're welcome! We are always happy to help. If you would like to give us a review on Google, we would much appreciate it: g.page/r/CcVUrahZNozMEBM/review We hope that you have a great day!

[@edkent7195]

Good video. Showed just what I needed. Thanks guys!

[@BkLiveWire]

The threads are stripped on my crankshaft. Can I use a 10mm die to rethread them or should I just buy a new OEM crankcase?

[@aprhys9494]

Fixed my weedwacker, thanks!

[@Plastikiando]

I fix my husky 129lk using this repair help. Thank you guys!

[@pierrerossouw3209]

Great video. Helped alot. Thanks.

[@skitso8948]

Just what I needed to know and see. Thanks

[@roberthubbard7424]

What happens if you do everything shown, but nothing happens besides me pulling the cord out, then it retracting?

[@richgann95]

Thanks Man! Great Video!!

[@charlesshurland5904]

Very helpful.

[@pappannair388]

Mculloch b26 ps starter bridge replacement video please

[@terrysmith7454]

WERE CAN I GET THAT PART FROM JUST WHAT I NEED

[@dartmoormike]

I just did this repair - Starter Pawl Bridge - Genuine Husqvarna No. 503 87 33 05 which I got from lsengineers.co.uk an easy fix!

[@davehellyer9173]

it would be nice if they told us where we could get the part ..!!

[@js_1995x]

Why would it be hot with a broken recoil/pawl

[@matthewleake677]

if it broke while you were using it and you tried to immediately replace it

[@davidkelley7445]

How much is a starter pull assembly

[@demerdd7528]

thanks

[@dchcountry]

If a cord is inserted with the piston at the bottom of its travel, it is possible that the cord may exit through the exhaust port and a piece may be cut off and remain in engine when the piston rises under spanner tension. Therefore I think I'm going to inserting cord with piston near TDC, if I don't invest in a piston locking tool.

[@hhawki3]

why does the piston need to be in the down position when performing this repair?

[@Stephen_Strange]

Got to the point where I use a 10mm socket, then 💥💥💥the NUT starts WEARING away under my socket, this thing is on so tight! Anti-clockwise, and it's like lead! AAARRRGGGHHHH!!! Now I have a worn nut and I STILL haven't got it off to put the new one on! 😭😭😭 ...Moments later .... SHEEEEET - the NUT is moulded in with the Pawl, and not a separate Nut. Now I realise my mistake. DOH!!! 🤦‍♂🤦🤦‍♀