Hydraulic hand brakes mod on off-road mower (SCRAPPY)

[@Tennesseemountainhomestead]

Beautiful work as usual, happy to see a fresh video from you guys!

[@Biokemist-o3k]

Welcome back. Been a long time no see. Thanks for sharing the video with us down here in the States....

[@carstonfarnsworth6783]

have you guys ever considered stretching these and widening it enough to sit inside rather than on top? that way you'd have a lower center of gravity and imo be a little more capable, currently I'm looking into making a kind of go-kart with the power plant and chassis of a mower like yours just stretched and widened enough to squeeze 2 people in it, still have the manual transaxle, still engine in front, using a peerless trans, something I'm trying to figure out is I want to try to use a driveshaft from the engine to the transaxle rather than pulleys and belts while still maintaining the manual clutch pedal. I'm not the brightest mechanically but was wondering if you or anyone else would have any incite. thx, love the vids.

[@CODOutdoors]

Nice, great job!

[@coleohern950]

Can you do this on a hydro?

[@TAF2424]

what mods would you recommend for off-roading cheap, aside like a upgraded axle and atv tires>

[@notjon9588]

The rear hub was spinng on the axle in the brake test, did you guys know about that?

[@okoffroadmowers]

There is a spacer sleeve on the axle shaft between the transaxle and hub that can spin freely of the hub. However the set screws on the hub was loose, we noticed while we were in there and tighten them back up