I had a new spacer in the box for the rear shocks for a 2014 Sonata, and didn't know where it went. Your video showed that. Thank you very much!
@LonnieJohnson1 Жыл бұрын
Cool!! You're welcome
@GC25604 ай бұрын
You didn't need to use vise grips on the shaft. There is a flat at the top end. Put the nut on and then use a flexible ratcheting spanned while holding the flat. Easier and won't damage the polished shaft.
@LonnieJohnson13 ай бұрын
Yes I did, I didn't have a socket or racket with a hole in the center of it and it was rusted pretty good so I did the next best thing and it worked. You have to clamp it at the top because the top will never compress that far down into the shock.
@hmerced25 Жыл бұрын
Thank you sr. You help me a lot with this video!
@LonnieJohnson1 Жыл бұрын
You're welcome
@salevampir4 ай бұрын
Well done.Greetings from Serbia.
@LonnieJohnson14 ай бұрын
Thanks!
@kevinmetcalf6371 Жыл бұрын
Straight to the point thank you
@LonnieJohnson1 Жыл бұрын
Your welcome
@SIRNUNOO-ej6gwАй бұрын
cool video
@LonnieJohnson1Ай бұрын
Thanks!
@MelRusson3 ай бұрын
Very well done .
@LonnieJohnson13 ай бұрын
Thanks!
@1981squirrel19819 күн бұрын
Great video. Should one use locktite on bolts or is it enough just to tighten them? :)
@LonnieJohnson15 күн бұрын
Thanks! You don't need loctite because the nuts are very tight. But it's up to you.
@humminaaa2 жыл бұрын
thank you
@LonnieJohnson12 жыл бұрын
Your welcome
@Yourpapi66610 ай бұрын
Any idea where I can buy new bushings for the shock
@LonnieJohnson110 ай бұрын
(Amazon) AUTOMUTO Rear Upper Shock Mounts Fit for 2007-2012 for Hyundai Elantra
@jeffblahblah52262 ай бұрын
Do shocks not need to have the air bleed from them any more?
@LonnieJohnson1Ай бұрын
I have never bleed air from the shocks because oil will come out. I have only adjusted the air in air shocks.
@jeffblahblah5226Ай бұрын
@@LonnieJohnson1 Back in the day we would pump the shocks 8 to 10 times to full extension with the shock standing upright. The first 2 or 3 pumps you would get a squelchy noise then the shock would firm up and be silent.I havent seen it done in any videos but we were taught it 30 years ago
@LonnieJohnson1Ай бұрын
I worked at a shock assembly plant and now days they have a machine that pumps each shock in order to make sure the shocks work and to make sure they pass QC before packing them for shipment.