I Axle Swapped to the Chrysler 8-3/4 - Part 3, Installation

If you would like to support my channel and the Mopar community at large by buying a Jonny Mopar shirt click the link below.
jonny-mopar-me...

[@Captaincurtsgarage]

Thank you so much for making these videos Johnny I'm putting together an 8 3/4 from just a bare housing. This will definitely help

[@JonnyMopar]

You’re very welcome. Good luck on the rebuild, you got this.

[@Coelacanth97]

Just discovered your channel and found many of your videos helpful and informative! I have a '70 Charger 500, bought it when I was 18 in 1986...it's at a body shop getting body & paint done, but I'll have a lot of work to do when it's finished. Your videos will really help me out. Thanks!

[@JonnyMopar]

Thanks man. I greatly appreciate the positive comment.

[@javimacias1215]

Very nice and detailed assembly, Jonny! Keep up the good work.

[@JonnyMopar]

Thanks Javi.

[@Captaincurtsgarage]

Love the videos Johnny . love the videos with your son.

[@JonnyMopar]

Thanks buddy. Greatly appreciate the comment and thanks for watching.

[@JustMoparJoe]

A fine rearend indeed Jonny!

[@JonnyMopar]

Thank you Joe

[@rikubot]

Love your videos. I like the way you explain things and film. Also very relevant to me as I’m building a ‘69 charger with a lot of the same parts 🫡

[@JonnyMopar]

Thank you rikubot. Yep, pretty much the same parts just a different skin.

[@RandallSoong-pp7ih]

Thanks for the tips and install and part numbers!

[@JonnyMopar]

You’re welcome Randall. Thanks for watching.

[@Greg383BB]

Great video, I will use it too rebuild my rear end

[@JonnyMopar]

Thanks Greg.

[@1968charger]

Another great informative video!!! THANKS

[@JonnyMopar]

Thanks man. I Greatly appreciate that.

[@maximuswedgie5149]

Awesome video Johnny

[@JonnyMopar]

Thanks Maximus.

[@davidstarsky6435]

Great video

[@JonnyMopar]

Thanks David.

[@moparnut6286]

Furnace tube brush makes a great tool to clean out axle tubes not that expensive either.... Nice 8 3/4.

[@JonnyMopar]

Great tip MoparNut. Thanks. I have to get one.

[@TheProchargedmopar]

👍💪

[@cartersgarage392]

Does the inner axles seals need to go all the way in to the little raised ledge of the housing?

[@JonnyMopar]

That’s how far I pressed mine in. There’s probably some allowance as long as the bearing sleeve doesn’t hit it when you put the axle in.

[@wht240sxka]

Music 👎🏻👎🏻