Ignition lock cylinder replacement

[@sammyat56]

Thanks again. I tried to purchase the Dorman cylinder in your video- they don't have anymore, they have another one for $155. I know that Dorman offers good replacement parts. I will look in a few other places and follow your video installing it.

[@CharvelGrinder]

I believe it was Standard Motor Products for the ignition lock cylinder. Dorman was for the windshield wiper reservoir tank cap!

[@keithbarbee505]

Yes you totally help me with the shear bolt thing and how to get my old ignition lock,on an infiniti i30,1998 model

[@CharvelGrinder]

Glad I could help!

[@Dean-sb9lj]

Did not know about the sheer bolts started working on mine and discovered that there is no way to remove the entire switch unless you do what you explained in this video thanks i didn't know how it come out

[@CharvelGrinder]

You are welcome and glad I could help you out!

[@juancovarrubias3355]

comments were turned off for your Water Heater video so I came here to say thank you! couldn't figure it out

[@CharvelGrinder]

You are welcome Juan! Thanks for letting me know it was disabled. I went and fixed it. Some KZbin policy update. Glad I could help!

[@GavinScott-h6b]

Thanks. Very helpful

[@CharvelGrinder]

@@GavinScott-h6b glad I could help!

[@AlfredoRodriguez-uh6rn]

From What year is that ignition switch

[@lastzulu180]

you helped alot

[@CharvelGrinder]

Glad I could be of some help!

[@MrSilvernblackblood]

Do you know if the back part with the wires sticking out can reused on the new lock cylinder?

[@CharvelGrinder]

The part with that the two wires come out of? That is the whole assembly for the ignition lock cylinder. If you buy one that is “Ignition lock cylinder” you get the entire piece that is in the video.

[@venjames4492]

Did it come with the starter switch

[@CharvelGrinder]

Everything you see in the video from the factory one I took out comes with the new OEM. It’s plug and play nothing else needed. At least when solving my problem.

[@sammyat56]

Thank you for the video. Is it possible in the 97 pickup to only change the key cylinder? My key is worn out and getting a copy doesn't work, but everything else is working. I tried key shops and all the keys they copied didn't work . I have search for videos to remove, only the cylinder but have not found any.

[@CharvelGrinder]

That is the issue that was going on with my truck. The key was severely worn. But it worked on the doors just fine. Also the pins in the ignition cylinder were too worn out. I could start the truck with anything. A paper clip, a screw driver, etc…. That is why I just changed the whole ignition lock cylinder. In doing so though, you would want to rekey the door lock to the new key or you have to carry two keys. The original and the new. So doing the ignition lock cylinder is replacing the key cylinder. I hope that answers your question. You get the whole assembly I showcase.

[@CharvelGrinder]

*flat head not Phillips screwdriver