Install Altaros Regulator and QuickFill to Cometa Orion

[@xe2ac]

Great video, this just what I was looking for!

[@capras626]

I bought the same weapon second-hand with the same charging port but it is impossible for me to inflate, it is as if the air does not have enought power to open the valve...can you give me any suggestion please?thank you

[@AirgunRegulator]

First, check that air is flowing into the airtube a only the pressure gauge does not work. If the air is really not going into the airtube, then it will be best to release the rest of the air and unscrew the plug with the quick fill and check the check valve and the opening to it that it is not blocked

[@capras626]

@@AirgunRegulator thank you very much!

[@anceco-jv3ds]

muy interesante el video , pero por ejemplo en las orion bp que vienen ya con regulador , como se tendria que sacar el regulador para cambiar la presion de tarado y donde podemos conseguir la barilla en el caso de que sea igual que el de altaros, tambien he visto la herramienta para aflojar y apretar la valvula pera esa herramienta es fabricada por vosotros o se puede comprar asi.

[@AirgunRegulator]

It is possible that our regulator is already installed in the rifle by the manufacturer. To remove it is necessary to use a rod with thread M7x1 which is screwed on the regulator. The rods should be included.

[@najeebhamad1728]

.When I saw the video I noticed there was not a small aluminum room between the regulator and the valve is this normal. when I installed the regulator in the Cometa Orion BP, the pressure is kept at 130 bar and after hours I notice it increases up to 200 bar. What is the problem?

[@AirgunRegulator]

I do not know exactly what you mean "aluminum room". On the video is used aluminum chamber with black anodized therefore does not look like aluminum. The problem will be leakage either to the o-ring between the black chamber and the brass regulator. This o-ring must be gently squeezed between the two walls (slightly fingers). The second option is a large o-ring that seals around the airtube. It is advisable to check it or clean it. If there was some dirt in the airtube so this dirt just sits on this o-ring when the regulator is inserted into the airtube. It is also advisable to check the quality of the airtube surface. Send other communications to mail [e-mail] where we answer faster.

[@eozutf605]

What is the pressure set (factory setting) in the regulator, is it adjustable?

[@AirgunRegulator]

The pressure is set according to the power requirements specified in the order. Yes is adjustable: www.altaros.cz/en/content/7-regulators (bottom of the page )

[@dr.leonardovolpe8213]

Onde tem esse Kit?

[@AirgunRegulator]

Hello: www.altaros.cz/accessories/86-cometa-quick-fill-with-manometer.html

[@uricamajstorovic3594]

Hi did I have a more shots for Cometa 5,5mm after instaling regulator or only cocnstant speed?Thank's.

[@AirgunRegulator]

Hi, installing the regualator is always a goal to maximize the number of consistent shots. Installing the regulator can not increase the number of shots per fill.

[@mauromontero3768]

Hola tengo una cometa orión bp Calibre 5.5 y no es regulada me gustaría colocarle la válvula reguladora sabe dónde la puedo conseguir desde ya Muchas gracias

[@AirgunRegulator]

helo write preferably to our email [e-mail] and please add a photo of your rifle so that we can verify the compatibility of the model.

[@abvgzze]

Ja sam kupio polovnu cometu orio spr koja nije bila sa regulatorom,kasnije je ubacen regulator.I sad nemogu nikako da ga skinem,bojim se da ne polomim nesto,nece da makne kao da je zalepljen.

[@AirgunRegulator]

technical matters must be resolved at [e-mail], where it is appropriate to describe the situation in more detail.

[@dr.leonardovolpe8213]

Kit?$$$?

[@AirgunRegulator]

www.altaros.cz/45-cometa