installation of mmr guide plates and timing of gen 3 coyote.

[@kevinames9267]

what did you torque the actual phasers too ? im in the process right now and i snapped a phaser bolt.

[@tripstomexico9770]

Geeezus I couldn’t take it after 2 minutes in😅🤦🏻‍♂️ my guy just take ur time specially when dealing with new billet parts.

[@coyotehd816]

How’s this motor holding up? Genuinely curious 👀

[@ericsvt1]

Its been running fine, i daily the truck.

[@jafo49]

My gen three exhaust phasers are different. The timeing marks are are closer together and the L and R are on opposite places. Including the teeth on the marks they are only seven teeth apart.

[@JDSWODA]

This is how mine is, did you ever figure it out?

[@jafo49]

@@JDSWODA I found a few videos that were the same as mine so got it back together and it's running good.

[@overlordofjellybeanz6149]

I want to swap a gen3 f150 engine into my mustang, any advice with wiring it all together?

[@ericsvt1]

Control pack makes it soooo easy

[@СизыйЮрка]

бро, ты лучший

[@EderVelzquez]

Cual es la diferencia de arboles

[@FernandoMontenegro-db9ft]

La información no es correcta no se pone apunto de esta manera

[@gabrielmoreno7326]

Cual es el procedimiento correcto

[@tikimanguzman6045]

El tiempo si está bien puesto.se jira 360.grados en ese modelo 2018 pero lo que no me gusta que el que está tomando el video. No enfoca bien los puntos