Installing Accessories on a Pontiac Engine

[@neilengward1563]

Lokar carb/trans cables and brackets worked for me.

[@Rustrevivalgarage]

I’ll check them out! Thanks

[@jeffreyrigged]

cant wait to see it run

[@Rustrevivalgarage]

You and me both! I'm sure there'll be lots of issues (esp with the wiring) but she's a Pontiac. They're hard to kill :)

[@russbonneau9152]

if you used a quadrajet things would line up. i had that same problem until i went that route. also you can NOT use that spacer with a clutch fan. you need to buy the studs that go into the water pump.

[@Rustrevivalgarage]

@@russbonneau9152 Is it because the fan clutch is too heavy guy or that spacer? If you can, could you let me know more about the studs? Thanks

[@Rustrevivalgarage]

@@russbonneau9152 Actually I think I found the studs you’re talking about. Thanks again!

[@russbonneau9152]

@@Rustrevivalgarage btw, you have to take it off the fan and install it after the radiator and shroud are installed.

[@Rustrevivalgarage]

@@russbonneau9152 Yep. It's already off. I wanted to have a more complete video, but found it was still in the way for some of the things I needed to do for the wiring.

[@raimaker6343]

Why would you use a used intake gasket on a brand new motor? Not worth the risk.