Installing ARP headstuds in my 4g64 block.

[@okayplayer1911]

Good to see you keeping this build going! Nice!!

[@tavariwilliams9233]

Keep sharing bro! I’ve learned a lot from you so far!

[@wombatspork1790]

Keep it going man!

[@orlandoa.padillamontanez2977]

Man can't wait to get that twin cam

[@wombatspork1790]

Atleast they didn't bend the head gasket

[@hollerican]

I have a question.....will that head gasket fit my 3g 4g64 SOHC....same block right........that head gasket looks way better than the MLS ones on eBay......thank yu

[@RvaJay]

It’ll fit the block, not sure if all the ports will line up with the head though.

[@hollerican]

@@RvaJay thank you for reply

[@hollerican]

I'm doing my job today..I ended up going with the same gasket you used on my 4g64 sohc....the gasket matches and looks better than the OEM one for the Sohc....I also used the copper spray just in case..I owe you for this video......thank you so much

[@islandboiilee7749]

Did you use the g4js gasket

[@RvaJay]

I’ve used both the G4js and 4g64

[@davemoto9249]

Bro I’m building a galant es rn what do u think the first thing I should do is I’m just tryna make a nice lil fast daily but reliable

[@RvaJay]

Maintenance and more maintenance. Change belts, gaskets oil/water pump. The maybe a small turbo setups

[@RTRtm13]

Hello there, how do you remove the front license plate holder from the 2003 Mitsubishi Galant, because I’m unscrewing the screws that hold it in place but it doesn’t go anywhere and it just spins, it is also rusted, is it most likely doing that because of the rust or is there something else holding it into place?

[@RvaJay]

Mine were screwed into the plastic bumper. If you pull outward on the plate holder and loosen the screw it should come out.

[@RTRtm13]

Ok thanks