INSTALLING MICRO-TRAINS ON A KATO N SCALE LOCOMOTIVE

[@n-scaleunionpacificevansto6569]

Thanks for this great tutorial, Mike, because I've got to replace my Kato couplers with Micro-Trains couplers as well, when I'm finally able to get around to it. I just hope the little pieces don't go flying, never to be found again. Your video will help me do it. ...Roy

[@CajonSub]

Great video, thanks for sharing - I needed this tutorial as I’m swapping out the couplers on the Kato locomotives. Very fast and easy. - Steve

[@unkownuser8645]

Fantastic demonstration…..I have 2-Kato locomotives awaiting the exact same procedure. Thanks 4 sharing…..🎉

[@garykcs5532]

Thanks Mike I havevyo do about 20 kato locomotives...Gary

[@dexterdog62]

Nice tutorial. Very helpful. Thanks for posting.

[@lonebeagle]

Great video!

[@bkdexter79]

Agreed! Excellent and informative video! Pretty easy to do, but this gave me the confidence to foresee the end result.

[@ibiubuok]

Your video was very helpful. Thanks for uploading.

[@michaelsullivan3581]

Thank you sir!

[@mikecottrell6525]

thanks for the info. just picked up my first train set n scale. pick out pieces to make set kato locomotive 3 rolling stock a caboose. two micro train cars a bachmann and some other one. if you click them together they work but if back into to them they don't connect so iam going to switch all off them to micro train one. want to do the magnetic coupler playing thanks.

[@NedWing]

Great vid helped out

[@XORRAIL]

Thanks for sharing this

[@rayopeongo]

Thanks for the video. I just tried the conversion after watching another video, and ran into problems. So, I watched yours, and found out what the screws in the package are for. The C clips didn't fit around the Micro-Train couplers, I assume because they were just a little bit thicker than the Kato couplers, and the C clips wouldn't snap back into position. I guess the Kato loco in the other video wasn't quite the same as mine. So, I dumped the C clips and used the screws instead, bingo! Thanks again.

[@mike937739]

Your welcome.

[@jackiestophel5969]

Is possible to show how to replace the Kato couples from an Amtrak AC-64 Electric Locomotive. Thanks

[@mike937739]

I don’t have that model so I have no answer for you.

[@richharris9489]

Micro trains chart says 2004 is the 1015 height ok ?

[@mike937739]

Yes, I have had to shim the back side on some to correct some droop in the coupler.

[@mike937739]

Yes, I have had to shim the back side on some to correct some droop in the coupler.

[@mike937739]

Yes, I have had to shim the back side on some to correct some droop in the coupler.

[@mike937739]

Yes, I have had to shim the back side on some to correct some droop in the coupler.

[@mike937739]

Yes, I have had to shim the back side on some to correct some droop in the coupler.

[@DavidAmmerlaan]

Wouldn’t you rather replace all with kadee

[@mike937739]

Only the trouble makers. Most seem to work good, now and then one doesn’t want to play good.

[@AbelG8781]

Kadee N scale??

[@richharris9489]

I use micro trains just swapped out 2 sd 40 2 the other day .much better now.