Installing Soffit Fascia ||12x24 Home Addition||

We are getting started on a new project for a client, this is a two story 12x24 home addition in which the bottom will match the existing walk out basement and be a dedicated shop, and the upper floor will match the main floor of the home, adding a full bathroom to that floor with an extra living room/flex room. Here I am installing the pvc soffit and aluminum fascia for a nice clean look.
All of our Gear can be found on our Amazon Storefront.
www.amazon.com...
There is no extra cost, we just get a small percentage of purchases.
Jamaica Cottage Shop Quality Outbuilding Kits
jamaicacottage...
We do receive a small amount of commission from your purchase but it does not cost you any extra.

[@1959whitesox]

Those 2x10s make it stand out so much hehe…..I am just starting my project like yours and have been watching all your videos they are great….i start framing my sunroom/addition next week

[@1959whitesox]

I’m using 2x8s for my roof rafters

[@nkel6111]

admittedly a rookie but if...and it's an ''if'' ...that you show the final product as you progress, like a flash ahead. So we,I can see what its gonna be...the final work. . little detail but it would look so professional.. To me that would be final . consider that. and lotsa close up with angles is...wonderful. ty

[@BreakFreeHomestead]

I'm having a hard time understanding what you are trying to say

[@willyhescalonac7546]

Good Job

[@BreakFreeHomestead]

Thanks willy, youre the man. 💪

[@jrac863]

Is that steel facia?

[@BreakFreeHomestead]

@@jrac863 aluminum

[@LastTrump7]

@@BreakFreeHomestead​​⁠Out of my whole house soffit I have about 10 ft on the back porch where the soffit was cut maybe a 1/4 in to short and does not hold in the lip of the inner F channel to keep it from sagging. Any idea of a easy fix without tearing that 10 ft section out and replacing it with little longer pieces. I don’t want to do that because the other sides are screwed in and are covered with the fascia trim.

[@andrewpower-gs8bz]

What's with the plastic jay?

[@BreakFreeHomestead]

The F channel?

[@edwardzo4371]

@@BreakFreeHomestead is the f channel installed upside down? I would assume the nail openings would be on the inner part

[@CluelessEngineer]

​​@@edwardzo4371 I noticed that too ahahah. Its upside down at 2:50