In this video I run through what is need to get this Ebay intake manifold ready for installation If you have any questions, let me know in the comments! Also please subscribe for more content like this
Пікірлер: 17
@CL9k24a37 ай бұрын
When portin use 70 %alcohol and liquid hand soap mix. Makes porting way faster
@FixStuffDaily4 ай бұрын
Thanks for sharing looks halfway decent for what you pay!
@jasonlinnell15754 ай бұрын
Good sh!t. I just bought a k24a3 & 6spd for my dc4. Researching/collecting parts. Def be following this build. Cheers ✌️😎
@damonryn4 ай бұрын
Appreciate it brother, happy to help with any questions too
@EK4rguy6 ай бұрын
Quality looks to the same as the S2 ultra street mani I got, ended up porting/polishing it to help remove the access material/casting marks left in the ports
@Chris-gs6rt7 ай бұрын
Looks great slowly coming along
@onlyunojhuno29 күн бұрын
Did you let the pcv vent to air or did you block it off ?
@damonryn29 күн бұрын
@@onlyunojhuno still got to figure this out, I think I’ll put it through catch can then back into the intake as West Aus regulations don’t allow you to vent to atmosphere or block it off
@dirkdiggler33153 ай бұрын
theyre skunk 2 manifold without the badge. s2 will buy them thro the badge on and resell it
@dirkdiggler33153 ай бұрын
its all from china
@TheJNALife7475 ай бұрын
nice work bro.🤜🏽🤛🏻💯🔥
@Moueez6 ай бұрын
How much mm i need to open the inyector hole?
@damonryn6 ай бұрын
I believe it’s a 14mm, the aluminium it quite grippy so watch out
@vtecminileon2 ай бұрын
This Chinese knock-off are pure shite inside the intake manifold. For anyone who's on a budget use an OEM one as they actually pickup more power
@myrx25 ай бұрын
You would be shocked what they look like inside if you cut it open. They might look good from the outside but the casting on the inside is absolutely horrendous!
@damonryn5 ай бұрын
Yeah ok, I’m on a budget so got no choice
@myrx25 ай бұрын
@damonryn if you know someone who can tig alloy then cut the bottom open and clean the inside up with a die grinder then weld the section back on. Seen a video of a guy comparing one to a skunk manifold and wondered why it flowed so bad so cut it open to see why. The casting was so inconsistent. Dags everywhere. Wasnt to bad after he cleaned it up. He also milled the gasket surface cos it was warped real bad and leaked when he first bolted it on.