Installing the hot water system in my motorhome

[@ryankirk2459]

You are doing a good job. Couple of tips for you: * When putting thread tape on male threads, holt the fitting in your left hand - thread on the right side, put the tap on clockwise, over the top and it wont come off. * If you have a fitting not line up vertical or to a specific position, just add or remove some thread tape and it will change the end position due to the thickness of tape used. * To stop the water spiting and remove the air, leave a tap on & on hot when filling the tap.

[@stevedickson4912]

With your John guest fittings you can get inserts to go in the Pipes and locks for the fittings , fit them to your hot side ,stops the pipes from popping of when they get a little soft.anywhere that sells the fittings will have them

[@AGirlADogandABus]

Yes I did use those in all my hot water connections. I showed them in the video I did on the freshwater plumbing.

[@stevedickson4912]

Ok sorry I missed that bit love your setup by the way

[@dawngrey259]

Congrats! That has to feel pretty good to get that accomplished.

[@littlerubster]

Although I'm a more infrequent traveller than yourself, I hope to meet you on the road some day. I think you're incredible.

[@ethanaperaburling5232]

Does this hot water heater require a open vented mixer tap?

[@mattberend5894]

Looks good. Except I think the pressure relief valve goes on the hot side. You may want to double check your instructions

[@AGirlADogandABus]

The instructions say to attach it to the cold water inlet. So does the installation video by the manufacturer.

[@kyliedavis7595]

Do you seal up all the holes through the bottom of the bus that all these hoses go through?

[@AGirlADogandABus]

Yes. I put silicone all around the hoses where they go through the floor