Installing the LCN 6400 COMPACT Series Low Energy Operator on an existing LCN 4040XP Door Closer

The LCN 6400 COMPACT™ Series low-energy operator is a simple and cost-effective solution that enables facilities to automate more openings for touchless access and accessible operation. The modular design is unique and allows the reuse of an existing LCN 4040XP mechanical closer. The electrified module connects with a mounting plate and just four screws and drives open the mechanical closer. The simplicity of this solution reduces the cost, labor, and complexity required to automate an opening.
Featured Products:
LCN 6400 COMPACT™ Series Operators: www.bannersolu...
LCN 4040XP Series Closer: www.bannersolu...

[@jtock133]

Per the directions, the arm bolt and the screws holding the mounting plate to the closer must be secured using a torque wrench. This is not optional.

[@michaelbebout7346]

How about showing where the other end of the wire goes and how to hook up the other end

[@davedav214]

Why do you start the video with it already mounted on the door. How about starting from scratch with the measurements for mounting?????

[@jtock133]

This product was designed to be added to an existing 4040XP or older 4041. It can also be installed as a totally new installation with the 4040XP. There is an install video here on KZbin that will show installation of the 4040XP.