Introduction to Slip Rings

Want to learn more about Moog slip rings? With over 35 years of experience, our Business Development Specialist will introduce you to the basics of slip rings and how they are designed and manufactured. You will learn about the internal workings that allow for the transmission of power and data as well as learn about the assembly itself. We cover the different sizes of slip rings that are used in sensors, inertial navigation platforms and wind turbines.
Next Video: Resistive Noise • Slip Ring: Resistive N...
For more information, please visit: www.moogsliprings.com
SOCIAL
Twitter - / moogcomponents
LinkedIn - / moogcomponents
Find out about Moog career opportunities by going to www.moog.careers

[@DanielCanestaro-Garcia]

This was such a good video from a guy who knows his stuff. thanks!

[@danielgalanos978]

I look forward to seeing more about slip rings. Specifically, material considerations, contact design, MTF. Thanks for the solid video!

[@CmdtJoshua]

Great video, with a such a great explanation. Engineering at its best!

[@Tadesan]

Powerful engineering right here. Well done!

[@brido88]

This was a great video, thank you for putting it together! Edit to add: This guy needs to do more videos!

[@2lefThumbs]

Nice intro, looking forward to the follow ups👍

[@diegopena7744]

Thank youuu, i just learned what these are and your video explained it quite clear

[@author_satpreet_singh]

Amazing explanation sir.

[@mammamia2418]

Thank you, that helped a lot

[@avnishpathak1311]

Really helpful sir.. Thanks a lot

[@linggiman]

Thank you for sharing your knowledge sir

[@askal916]

Your video was very helpful. I would like to ask you to help me visualize how 5 independent signals (5x12) could be conducted to a stack of 12 independently rotating rings/disks on a common shaft. I am an amateur artist attempting to create a moving sculpture piece. The rings would be more or less 1/4" thick and 1 1/2" to 24" in diameter. The common shaft diameter could vary but smaller of course than the smallest disk. This seems a little backwards or upside down from your video and I can't seem to wrap my head around it. If you have any thoughts even if it is that it can't be done, I would appreciate your input. Thanks in advance.

[@quinnfoster4671]

make Beryllium copper (BeCu) spring contacts and slide them against copper rings. OR just buy cheap capsule slip rings

[@tr1p1ea]

Nice video!

[@hedayatullahkhan3940]

Great post thanks

[@abusaeedashrafi8518]

Please explain this issue in my packing machines. A lot of slip ring has been failure during a weak. Firstly I would like to explain. My machine three phase harness cable is too far from transformer, there power cable is too remote from machine power input

[@_monti142]

nice video

[@jasonjohnson6216]

Thanks

[@abhia6441]

Nice video

[@briantatum8335]

can you use a slip ring on a welder?

[@cliffcosynerflight5253]

how much RPM can a Slip Ring handle?

[@randomtux1234]

1:01 that device on the left of the table half clamped onto the edge of the table is making me nervous

[@venkatseshaiah5834]

Dear sir Kindly let us know the procedure to rest sliprings pertaining to the insulation resistance and what is the max voltage which can be used which the slipring can withstand ie 220 or 415 volts What is the insulation resistance required between ring to ring when measured with a megger of 1000v from Sreedhar india

[@small3687]

Pay an engineer to figure that stuff out.

[@gradientgamer5480]

i call em collector rings

[@TheUnofficialMaker]

how hard can it be