Inventor 2020 | Radial Engine | Piston Ring | Vol. 12

[@camilosalcedojimenez4536]

Hi mate. Sorry to bother again. I just noticed in the drawings, the first extrusion was of 1.5mm while in the video is of 1.0mm. Which one should I follow? Thanks!

[@CADPond]

Hi Camilo! Mistakes were made, as I am not immune to them. However, it would be better to follow the drawings dimensions instead, because I corrected mistakes later in the process. So if you follow the drawings, you wont need to correct those mistakes later. Edit: I just checked the assembly video, and i adjusted the dimension to 1.5mm. Lol, i hope this is not late.

[@studymotivation3753]

Completed on 27/01/2022 71 more to go🙏 Hope u have a Good Day🙌

[@CADPond]

Lol, you too soldier! Carry on!