iPhone 11 Battery replacement and removing the important battery message

Finally a battery replacement video from iTouch.
Yes, here is the correct way to replace a battery on the new iPhones (from iPhone XS - iPhone 14).
The solder and battery holder:
a.aliexpress.c...
The drill:
a.aliexpress.c...
Qianli copy power programmer and controllers:
a.aliexpress.c...
As for the batteries, I have a local distributor, so I can’t share a link to them.
You can send your device for this or any other repair.
contact me here:
[e-mail]
Or simply, you can contact me on Facebook or Instagram link below.
Instagram:
...
And on Facebook:
/ itouchpro
#microsoldering #batteryreplacement #iphone11
keywords:
iphone 11 battery replacement,
iphone 11 battery drain test,
iphone 11 battery change,
iphone 11 battery health dropping fast,
iphone 11 battery percentage,
apple iphone 11 battery replacement,
apple iphone 11 battery health dropping fast,
how to replace an iphone 11 battery,
iphone 11 battery boost,
iphone 11 battery bms swap,
best iphone 11 battery replacement,
iphone 11 better battery life,
iphone 11 battery cell replacement,
iphone 11 battery charging problem,
change iphone 11 battery,
calibrate iphone 11 battery,
how to check iphone 11 battery health,
how to change iphone 11 battery to show percentage,
iphone 11 battery drain problem,
iphone 11 battery draining fast,
iphone 11 battery drain,
diy iphone 11 battery replacement,
why does my iphone 11 battery die so fast,
iphone 11 pro battery drain test,
iphone 11 battery replacement without error,
how to extend iphone 11 battery life,
how to enable battery percentage on iphone 11,
iphone 11 battery fast drain,
iphone 11 battery fix,
fix iphone 11 battery,
how to fix iphone 11 battery health,
how to fix iphone 11 battery draining fast,
how to fix iphone 11 battery not charging,
iphone 11 battery health increase,
iphone 11 battery health not showing after replacement,
how to change iphone 11 battery,
how to remove iphone 11 battery,
how to maintain iphone 11 battery health,
how much cost to change iphone 11 battery,
how to increase iphone 11 battery health,
iphone 11 battery issue,
iphone 11 battery issues after update,
iphone 11 battery is draining fast

[@mewanksta11]

I have an exam tomorrow why am I watching this

[@AllInformationUpdate]

Same bro 😂😂

[@Tune7tastic]

Same 😹🙌

[@Invisible__men]

Poyi padikada😅

[@muhammadkamil126]

that is a lot of hardwork

[@BSnicks]

Another reason why my last iPhone is a 6S+.

[@SandunC320]

Wow so satisfied with your commitment to the job

[@KinngMobziie]

This is a superb video but not easy repair

[@petr5178]

Is it good to heat the battery with the soldering iron? I think that spot welding is a lot better for the battery cell

[@iTouch-repair]

@@petr5178 I didn’t hear the battery, did you see me heat the battery it self? I used very low temperature and low temperature solder for this repair, so it’s all good. If the battery cell turns out to be damaged, how are you gonna replace it with the spot welder? Also, these cells don’t have a long life as they are all recycled, and after 6 months you will need to replace them again, how are you gonna replace it then?

[@petr5178]

@@iTouch-repair the battery heated really quickly inside from soldering the outlets - this isnt good for the chemicals inside. But anyways - new battery after spot weld is changed by grinding the welds - quick process. But no hate nice video👍🏼

[@Blade__susi]

At what temperature should your iron be while soldering cell and BMS

[@iTouch-repair]

@@Blade__susi at the Lowe’s where the solder can melt but not overheat the BMS. I would say 260-280C no more.

[@PunxTV123]

when reset/restore, it means no more battery health and error reveal??? so 2nd owner will notice that battery is replaced… ??? i am right???

[@iTouch-repair]

Hi, no, after reset/restore the old percentage will appear and that’s it.

[@tyniewicki]

I understand. Thank you :)

[@user-wd5bd7yw2n]

Hey can you send a link from battery you replaced because not all of them copy

[@iTouch-repair]

@@user-wd5bd7yw2n Hay, sorry I can’t, I am buying them from a local distributor.

[@klassiqphonerepair6782]

If I restore the phone ,the battery health would go back ? Or important messages would start displaying?

[@iTouch-repair]

the battery health would go back. the messages only appear if you connect a none genuine part to the phone.

[@jeroen207]

What if I don’t have another battery to display important message. What are the options?

[@iTouch-repair]

You can boot the phone through a power supply with 4.2V

[@alfiroyan462]

You are welecome and good jobs

[@yoriwardani469]

is this method still working with use removal tag on nowdays? or now must leave non removal tag on with the battery inside sir ?

[@nannsch]

Can i replace BMS without reset battery healt and cycle times ?

[@iTouch-repair]

yes you can.

[@shobhitsharma639]

Sir is it always show 100 na not degrade 99 98 always show 100

[@iTouch-repair]

It will drop with age, as an original one

[@denisik15]

Where you buy all parts? I have problem with that. Actuali cant find lot of parts and gived back damaged devices.

[@HermanCrantz]

Aliexpress

[@mrwelshaviation_024]

ifixit

[@RafalRybakowski]

Heyy man, do I need a third battery to start the phone or can I just use a cable to get the warning?

[@iTouch-repair]

Hey, you can use the cable and start the phone from the power supply to get the warning.

[@neiltaylor-smith1805]

Take it to experienced technicians. This looks pretty rough and prone to causing damage if you’re not experienced.

[@GnarledSage]

It shouldn’t be that way. It’s a stupid battery replacement.

[@randomkitty2555]

I saw a tutorial about how to use the Qianli programmer tool and at the end they leave the tiny board connected to the battery but you take it off. I'm confused, please reply.

[@iTouch-repair]

Hi, you can leave no problem but, the tiny board can cause issues like the phone won’t charge when it’s fully discharged (turned off). With or without the tiny board it’s the same but, for less issues in the future I remove it.

[@LeeMooEez]

You should leave it…because if you took it out…the reading will reset later on…but many took them out for cost/profit

[@iTouch-repair]

@@LeeMooEez no, not for profit only, many cases where the phones battery died and they couldn’t charge the phone from zero. Also many cases where there was a software issue and they couldn’t restore the phone because there was an error during the restore process.

[@LeeMooEez]

@@iTouch-repair I’m not talking about you haha but I talk about technician who told me that (he do that)

[@muhammadirfan3235]

@@iTouch-repairpercentage keep on 100 or will decrease and one more thing after update ios battery health back to normal health ?

[@nannsch]

Can i replace BMS without reset Battery Health ?

[@smifwesun2024]

То ж як краще замінювати з помилкою чи без помилки та не перепаювати контролер ?

[@iTouch-repair]

Немає різниці, то від вас залежить чи вам заважає помилка в системі.

[@smifwesun2024]

@@iTouch-repair просто було цікаво чи шкодить цей процес подальшій роботі акумулятора

[@iTouch-repair]

@@smifwesun2024 взагалі ні, я собі змінив теж батарею 3 місяців тому, все ідеально працює. Все залежить від батареї яку вам поставлять, так як китайські батареї різні.

[@GnarledSage]

Nothing happens. Just apple being an a$$hole. Forcing people to go their service and letting us know that we’re not really the owners of our devices.

[@BillAnon]

My soldering iron is rated at 900 degrees and is not adjustable. Should a purchase another iron before attempting this?

[@iTouch-repair]

Yes, you need to get an adjustable soldering iron.

[@tyniewicki]

Hello, why did you supply 4.2V to the BMS?

[@iTouch-repair]

As said in the video, to activate the BMS (turn it on).

[@tyniewicki]

@@iTouch-repair I understand, is it necessary? Only your manual uses this, other tutorial videos don't do this. Why?

[@iTouch-repair]

@@tyniewicki you can skip this step as the programmer has this function (injecting voltage to the battery).

[@BloomfieldBlanche]

Harris Daniel Taylor Richard Gonzalez Michelle

[@Her0Speedy]

Can i reuse tag on flex?

[@iTouch-repair]

If you mean the qianly controller, then yes.

[@manachyn]

Мова інтерфейсу видає країну походження)) Дякую за детальну інструкцію

[@raziqawan4090]

Is it possible to remove battery msg without original battery ? Can any one tell me

[@iTouch-repair]

No

[@rickschaap5742]

I dont understand why you shocked the BMS at 6:50?

[@iTouch-repair]

You mean injected voltage on the battery connector?

[@SerhioLe]

Привіт,що буде з кондицією батареї після оновлення системи?

[@iTouch-repair]

@@SerhioLe привіт, ви маєте на увазі що буде писати в системі про стан батареї?

[@denisik15]

he say - activation. But actualy i think He enable or switch on BMS. Like all BMS works samalery.

[@LeeMooEez]

To activate it because when you disconnect the bms it will deactivate the battery/bms

[@salt7582]

IF YOU RESTORE THE PHONE, THE MESSAGE COMES BACK?

[@iTouch-repair]

Without the qianli board yes.

[@LeeMooEez]

Yes…and that’s why you should not take the tag flex out and leave it in there

[@shobhitsharma639]

Brother iski battery health 100 se kam nahi hoti na hmesha 100 rheti hai

[@Pcut]

How to o inject 4,2 volts? U sid it with multimeter?

[@iTouch-repair]

No, I have the probes from a multimeter connected to the power supply.

[@Pcut]

@@iTouch-repair if i have only multimeter?

[@iTouch-repair]

@@Pcut you can’t start the battery. You can try connecting it to the phone and plug in the charger.

[@hamedsafi7715]

shouldnt be this hard to replace a battery need to stop company from making it so difficult

[@sigaretter]

почав дивитись, чую акцент і думаю:”дідько, знову пердушня та за шо” а потім бачу мову інтерфейса - порядок

[@GnarledSage]

Starting to hate apple with all this crap. I’m used to change the batteries of my iPhones since the first one. But, in the past years I had changed my phone often. This time I had to change the battery of a family member, assuming it was as it has always been, annoying but easy. And had to buy another screwdriver (Y) for some stupid screws, and at the end once I started the phone I got the “unknown piece” instead of the quality % of the battery. Only to find out that it’s now impossible for the home user to do this job and get the phone with 100% of its sold characteristics and that now you’re forced to go to apple for service or spend a ton in devices you’ll only use once and make some Frankenstein pieces with the old and new ones. Ridiculous. This “you’ll own nothing, and be happy” is bs, and it’s time we fight for our ownership rights and the right to repair our stuff.

[@ЛёхаБукреев]

Какой смысл в этом видео? Те, у кого есть программаток итак знают что и как делать. А те, кто не знают - не имею программатора. Для кого видео?

[@davidnelson3026]

your camera is too close and the music is disturbing