iRacing | How to get the perfect LAUNCH in the PORSCHE GT3 Cup Car, HE sprints and Fanatec V3

iRacing | How to get the perfect LAUNCH in the PORSCHE GT3 Cup Car, using the settings for HE sprints I show you how to map the clutch pedal for Alien level launches in the Cup Car with minimal wheelspin, then I show you a hack for the same effects by mechanically adjusting the Fanatec V3 Clubsport pedals. This might work for other sim racing pedals with a bit of brain work.
Smoking Steel Garage is a channel dedicated to DIY fabrication, Sim racing, and general motoring shenanigans. I'm no expert in any of the above, But with a "can do" attitude I can usually get it done! My aim is to motivate you to have a go.
If you see me doing something wrong or you think there is better more effective way let me know in the comments below!
Big shout out to my favorite channels and sources of inspiration, if you haven't followed them already head over and take a look.
Davecam
Boosted Media
Sim Racing Garage
Urchfab
Trev's blog
Homebuilt by Jeff
Bad Obsession Motorsport
Follow me on
Facebook Smoking Steel garage: / smokingsteel. .
Instagram, @smokingsteelgarage
Twitch @SmokingSteelGarage
The rig hardware is as follow.
VRS direct force pro wheelbase and Simline GT3 wheel
Heusinkveld Sprint pedals
Fanatec Clubsport shifter, Sequential and H pattern switchable
Carbon Kevlar Tillet race seat from a Caterham G7.
PC specs:
MSI Motherboard MPG Z390 Gaming edge
Intel core I5 9600K
EVGA GTX 1080 TI Graphics
Crucial P1 500gb NVME M2 SSD
Ransor Supersonic 16GB Ram, 2 x 8gb 3600MHZ DDR4
Castle 240R Liquid cooled CPU cooler
Deep cool DQ 750st Power supply
Matrexx 50 Case
Toshiba 4tb External Hard Drive
Triple 27'" MSI Optix Mag27c monitors, screens are set to 60° angle
Shot using Huawei P30 Pro
DJI Osmo mobile 3 gimbal
Razer Kiyo webcam
Blue Yeti Nano Microhone
Edited using Davinci Resolve 16 (Highly recommended and its free!)