Is Your Laser Losing Power? Not a Problem! Thunder BOLT Maintenance Tips. 024 4K

[@gusswenson7811]

Good morning Gord For all the people that are learning how to use their machine it is so Great that you share your experience and knowledge and you are sharing it.. I find it very interesting to watch and learn. It’s kind of funny that I love to learn even though I may never get to use it.. But I have a huge thirst for knowledge and enjoy learning.. Always have.. Just not Grammar. Hahaha Thanks for sharing your knowledge with us Cheers my friend. Say hi to Carol from us.

[@LaserNUG]

Will do - thanks Gus! Say hi to Sally!

[@thunderlaser.official]

Great video！

[@LaserNUG]

Thanks!

[@zeekesler2940]

Awesome Gord- I am literally planning to do my first clean today! This was timely!

[@LaserNUG]

Morning Zee! Thanks for watching!

[@petekleinschmidt4251]

Thank you for the great information I don’t have an engraver but would like to get one someday! I sure hope that thunderbolt appreciates all the great videos you’ve made about there machine! Cheers!

[@LaserNUG]

Hey thanks Peter! Cheers!

[@zeekesler2940]

I work at Thunder and we love Gord-we're his biggest fans! Super appreciate these videos!

[@petekleinschmidt4251]

@@zeekesler2940 It’s one heck of a machine! Gord does a great job explaining things in layman’s terms! Thanks for building a quality product!

[@veralopez2681]

Thank you GP, you are still teaching us something new everyday 👍 keep up the great job 👏🏼 just a quick question do you clean your Honeycomb too?

[@LaserNUG]

Thanks Vera. I am happy if it helps a bit. I have only cleaned it with soap and water once. it takes a bit to dry afterwards cause the water collects inside the frame, and the steel honeycomb rusts. However it is surface rust/discolouration - if you use a q-tip and dip it into each of the little honeycombs it wipes right off and shines like new. So now I just wipe it down with Windex multi surface cleaner and a rag and use my air compressor to blow it out. About once a week or two, depending on what I am engraving. Hope that helps!

[@olddawgdreaming5715]

Good morning Gord , thanks for the P M Tips and how to video. It's awesome what they can do with those machines. Keep up the great videos and the fun you have around there.

[@belindaotterson8123]

I have had my bolt since September of last year and I just learnt something new today! Thank you so much for your informative and detailed videos. So great!

[@LaserNUG]

That's great - thanks for watching Belinda!