Jaguar / Land Rover Coolant Leak Fix & Supercharger Snout Replacement .

[@UpstateRealtyGroupLLC]

Excellent Job! This is a great video with plenty of dealer spec information.

[@lear60man]

One of the best How To videos Ive seen a long time.

[@kyproset]

Excellent demonstration. I'll be doing the same job on my 3.0 S F-type soon. Where can I buy the gaskets and studs for this job from? THANK YOU.

[@Twgh]

Amazon

[@nznkmc]

Perfect work. Thanks for manual screenshots...

[@sadiqrehman947]

Great video I’m actually doing the same job was putting the supercharger back and on the drivers slide at the back of supercharger I connected the coolant pipe and the electrical sensor but on the passenger side I can’t seem to find or remember what plugs in to the port at the back

[@krisjarosz3316]

Great video, thank you! Do I need to take off the whole supercharger just to change the coupler ? Or will I be able to remove the snout without removing the supercharger? Thanks

[@itsheresy]

Great video. Question I don't see answered or asked much, do you leave the battery hooked up for this? If not, is it just like any other car where you just disconnect the negative and you're good to go?

[@E39M5SPEED]

@@itsheresy Battery negative terminal connected. 8 amp trickle charger always connected to vehicle to make sure battery doesn’t go below 12.6V. Any car that’s in my bay for over 2 hours always gets charger connected to it.

[@xuehaotan9292]

Nice video here, very helpful for my jaguar work. Just wondering what marker you are using on the bolts (green one) and why you are using them

[@E39M5SPEED]

@@xuehaotan9292 paint marker from Amazon. Once bolt is torque to spec it always gets a Green mark to make sure . On connectors they all get green marks also to make sure nothing is missed upon re-assembly.

[@leedavies6690]

@@E39M5SPEEDhi is this the same engine 3 litre diesel Range Rover ? I got a coolant leak where I got keep topping up few litres is there a common issues ?

[@manuelmuniz4190]

Hi, thanks for the vid. Could you tell me the torque for all the screws? Thanks in advance.

[@fernandomendoza8202]

To replace the nozzle for the coupler you have to take off the supercharger?

[@يوتيوبالعرب-ع1ن]

Awesome job, where is your location

[@E39M5SPEED]

33703. FL

[@يوتيوبالعرب-ع1ن]

I have 2010 XFR v8 5.0 , lol 😂 I don’t know how much will cost me to do that 😢

[@E39M5SPEED]

@@يوتيوبالعرب-ع1ن labor is $700.

[@charangandi2305]

5:57 may I know what is this part and where exactly does this go..? I have this part fall loose in between supercharger an engine block. I opened everything to change the water pump and thermostat. But after seeing this part loose in that area I found it would be a problem. Kindly let me know what is that product and where does that go. 5.0 v8 is my vehicle.

[@ChicaI-bi4gm]

How much oil did you put in the supercharger?

[@therealcyrus]

Hey man great video. Quick question, Do you have to replace all gaskets no matter what? Or is it just a good thing to do . I ordered all these parts but forgot gaskets i’m wondering if i should. Thanks

[@E39M5SPEED]

@@therealcyrus Everything.

[@therealcyrus]

@@E39M5SPEED Thanks for the swift reply brother. Have evrything ordered coming tmr. I havent done anything like this before but am taking this challenge on tomorrow. Before i start removing everything, do i have to take the coolant out from somewhere? i was lookign to completely empty all the coolant and replace it with a different one as i couldnt find the original brand thats currently being used. Thanks again

[@E39M5SPEED]

@@therealcyrus lower radiator hose. Remove it. Coolant will drain. Make sure to only use OE Land Rover coolant ! Not aftermarket. 50/50 mix with distilled water.

[@therealcyrus]

@@E39M5SPEED yo bro please help, i got the csr back together but no cooant flush i cant drain it please help me find the drain location last thing i need before finished with car

[@E39M5SPEED]

@@therealcyrus Huh?

[@amonm6594]

How much oil drained out of the supercharger?

[@Chewie374]

What is the plug behind the driver super chager? I pulled it up without some how unplug it. I can't do it? 2017 range rover 3.0 sport

[@charangandi2305]

Would you suggest the Updated coolant pipes that are metal..? If yes could you tell me the Torque specs of those if you have any idea.?

[@150_ENGINEER]

I would like to know this as well

[@michaeldotson658]

Why did you take off the intake when you can get to that piece behind the water pump without doing that? I just chnaged the water pump and that piece and its still leaking, I wonder if I messed up that seal when I put it in??

[@E39M5SPEED]

@@michaeldotson658 oil cooler.

[@E39M5SPEED]

@@michaeldotson658 yes you installed it incorrectly and smashed the seal again because you didn’t use any superlube o ring lubricant

[@SebastianK-b8e]

Very good thanks from germany :-)

[@amonm6594]

How did you pull apart the Snout from the supercharger the glue they use is too strong I am trying to do it now impossible

[@E39M5SPEED]

Vice and rubber Mallet.

[@JohnnyjayV]

Where could one obtain the repair manual for a 2017 Jaguar xe?

[@E39M5SPEED]

I used all data.

[@rahshenbarber3909]

Estimated dealer cost?

[@E39M5SPEED]

Takes me 2 days - 16 hours. I’m at $45 per hour.

[@4191good1]

@@E39M5SPEED How far are you from Knoxville TN area? 2017 F Type R 23k miles will need coolant pipe metal replacement sometime maybe preventative maintenance.

[@E39M5SPEED]

@@4191good1 st Pete Florida.

[@4191good1]

@@E39M5SPEED Do you have any excperience with the aluminum aftermarket coolant pipes for JLR 3liter and some 5 liter motors? I've been looking at Euro Amp that offers them and RXK which are supposed to be made in Europe. Metal seems better than plastic if it fits. What say you?

[@E39M5SPEED]

@@4191good1 yes. Go for it.

[@SimonNg-dj3qi]

Subscribed!! One of the best videos on youtube! From camera angle to explanation to every details... couldn;t be better.. Thank you so much... Also, would you happen to know what is causing this noise on my RRS V8 Supercharged kzbin.infopFXDfNHlTG8

[@E39M5SPEED]

One of the pullys. Or tensioner.

[@SimonNg-dj3qi]

@@E39M5SPEED Thanks again! much appreciated.