Adam, nice video. One comment you made about spark plugs that were hard to remove I have always used anti seize on the threads to prevent that issue. Aluminum heads are the most prone to thread damage. Permatex makes a good one and does not damage catalyst converters. The spark plugs come out real easy the next time. Thanks for making videos of your repairs/service
@LivingWithAClassic4 жыл бұрын
I'll have to try that one! I always put anti seize on my V12s and older engines that don't have catalytic converters. Didn't want to hurt this "modern" car. Thanks for watching!
@miketruglia48252 жыл бұрын
thank you adam. great video. very straight forward and to the point. i found it to be very useful. I look forward to any new videos you make on this particular make and model.
@cobbittycavoodles7123 жыл бұрын
Thanks Adam. I have a 2004 xj6 same engine. I thought the manifold had to come off. Now I know
@breckenridgecaineiii92013 жыл бұрын
did all, ran terrible when I started it up. please emphasize putting the small vacuum hose at the rear of the engine back on. now runs great. Much thanks.
@LivingWithAClassic3 жыл бұрын
Thanks for the tip!
@AndrewGruffudd4 жыл бұрын
You Vikings and your longbolts! Anyway, I've just got myself a lovely 2000 Jaguar S-Type with a 3-litre V6, and I'll be looking at your channel often. I'll also be creating a channel chronicling my adventures with the car, and hopefully it'll help me pay for its upkeep. Unfortunately, as it's under a warranty, there's a limit to how much DIY I can do with it.
@WestCoastDP2 жыл бұрын
I have the V8 version which will have a bit of oil dripping down into the spark plug channel because of a leaking oil cover and sometimes moisture. Save your money, take off the coil plugs and measure the ohms. Should be around 3 to 7 ohms which means they are fine. Clean out all of the oil, moisture inside and outside of the coil plug. Squeeze some clear silicone gel inside the coil cavity. Done, I've gone 40,000 without misfires.
@brandonback3037 Жыл бұрын
You mentioned to check and ensure no oil was on the coils or spark plugs. What do you do if there was oil present? Would this be a valve cover gasket or spark plug tube seal and what would you have to do to fix it? Thanks and great video I'm about to be changing the coils and plugs in my 2000 3.0 s type.
@alfonsomorales2399 Жыл бұрын
Thanks Alan, very informative.
@LivingWithAClassic Жыл бұрын
It’s Adam but you’re welcome
@lastspartanhh6360 Жыл бұрын
Hi great channel and great video, I have a 2001 s type, what I would love to know is how did you get the dash board error codes to come up, many thanks Anthony
@peterk45016 ай бұрын
Are the upper and lower intake gaskets recommended to be renewed on a 120,000km car
@tonyramirez27317 ай бұрын
Any videos on how to replace fuel injectors on a 2005 Jaguar S-Type V6 3.0?
@toobad99464 жыл бұрын
Ok, so you disconnected the battery. Now after replacing the coil packs and plugs the car starts. That's great! The only problem is the power doors don't lock, the left headlight only works on high beam, the right turn signal won't stop blinking, the radio only plays polka, the right rear tire lost pressure and everyplace you drive a huge bird craps on the driver's door handle. Every Jag should have a "Master Reset" button right on the remote control!
@tsp60672 жыл бұрын
👍Many thanx for this i appreciated! I will do this service for sure i want to buy S-type as well nice classic car i believe..
@peterexley49852 жыл бұрын
👌well done
@splinter196 Жыл бұрын
good vid i have a misfire on number four on my jaguar i have heard that the long bolts are prone to snapping heard of this at all
@LivingWithAClassic Жыл бұрын
So far they haven’t snapped for me but the Ford bolts are pretty weak on these cars
@blairmarchand75724 жыл бұрын
Something I will tackle on my V12 Hahahaha. Now that's a bear of a job! I'll be making mine a little easier in future by putting the A.C compressor to the axe.
@LivingWithAClassic4 жыл бұрын
It's not too bad on the V12. I would actually rather do it on a V12 haha I have a video on doing the plugs on a V12 too 😊
@romeosagayno22749 ай бұрын
Thanks for sharing. But i have traction control lights ON with check engine lights ON also.
@LivingWithAClassic9 ай бұрын
Time to read codes
@lastspartanhh6360 Жыл бұрын
Well thanks for your reply 🐝🧿
@stretchy126010 ай бұрын
I have the 2001 3.0 V6..... are there any gaskets to replace when refitting the intake...?
@LivingWithAClassic10 ай бұрын
Yes there are intake gaskets. Mine were pretty new so I reused them
@drajadfomaus568 Жыл бұрын
Hai. Can you help me. I found broken tiny hose in back of manifold ( red one on 4:36 ) and i have no cloue where it when. Thanks
@ozwatts2 жыл бұрын
good job - thanks
@rokospasov74022 жыл бұрын
hello Adam, I have a question.. when change new engine do we need recognition with the car?
@obadiahisrael71922 жыл бұрын
Hey thanks for the video had a question what is the torque for the air intake manifold bolts if you can please let me know I would greatly appreciate it
@LivingWithAClassic2 жыл бұрын
Sorry I don’t remember. I looked it up in the manual but left the manual with car when I sold it
@josephkeyes292 жыл бұрын
Hey do you have to change the coils when you change the spark plugs?
@josephkeyes292 жыл бұрын
I'm asking because after the plugs were replaced and the coils weren't. When the car was started. It stay on for a short period and it was missing and back firing a little.
@LivingWithAClassic2 жыл бұрын
It’s not necessary but I recommend at least replacing those under the intake. It’s silly not to
@maxmusterman60302 жыл бұрын
I have an 2002 S type which has a faulty Knock sensor (LH), so I have to remove the intake manifold too... I already ordered the Spark Plugs, coils and the Knock sensor, but I'm thinking of changing the Seals and vaccum pipes. I have 140k on it, last inspection was at 120k by an Jag Workshop (the pre owner was there). Do you think they changed the seals anyways and they should be fine if I'm using them again? I guess they changed the spark plugs at least at around 100k like it should be done 😅 Sadly the seals are not as easy to get as the other parts, that's why I'm thinking of using the old ones again 😅
@jacqueshenriot89493 жыл бұрын
Hello. Nice channel and useful tutos ! As you need to remove the intake manifold, do you recommand to change some gaskets or related parts ? Thanks.
@sicilyny53752 жыл бұрын
Thanks .doesn't look much harder than doing an old Chevy. Too bad the mechanic here freaks out over working on a Jag...😱🙄
@gsup64 жыл бұрын
Hi, I did the same thing changing the plugs, I got a vacuum leak in the back hook. If I take the manifold out would I be able to access it or needs more parts off! Thanks
@paoladiaz83923 жыл бұрын
Yes also need to take off the filters n the top by windshield wipers
@TheRobynhud3 жыл бұрын
New sub. Great channel, thanks very much.
@LivingWithAClassic3 жыл бұрын
Welcome! Glad you enjoy it
@barbas203 жыл бұрын
Hi friend!! One question... How to install catch can oil in jaguar s type 3.0???
@siddhantnayak20213 жыл бұрын
Nice video brother! Just a question, the tools you mentioned, are they the same for a 2006 S-type?
@simonandemmahallett20902 жыл бұрын
hi ,do you have a video in the vvt solenoids ?
@LivingWithAClassic2 жыл бұрын
No I don't, sorry
@126Flashbeatz9 ай бұрын
THX
@nossrc56383 жыл бұрын
Did you know where is the camshaft position sensor?
@breckenridgecaineiii92013 жыл бұрын
do you have a video on redoing the headlights?
@LivingWithAClassic3 жыл бұрын
No I don't yet but I plan to in the future
@robertosoto85004 жыл бұрын
Hey there. I have a question. I got the restricted performance light on. Nit so much of misfire but maybe a bit. Also it has lean condition for codes. And at 3k revolutions it starts to bang.
@darrycarter78682 жыл бұрын
What plugs did you use
@Keepitlit07834 жыл бұрын
Do you know where the engine coolant sensor is located on a 2000 jaguar s type by any chance?
@DA-ou7hv Жыл бұрын
I have a 2000 model same engine. Wish I knew good source of parts.
@255sol94 жыл бұрын
Thanks for the video. It's cold outside and I will have to wait until winter is over, but I will try to do this on a 2005. Don't have a heated garage. If there is oil in one of the spark plug housing, then what do you do¿ because you mentioned it was a bad thing. I have a coolant to engine leak and will be attempting a sealant once I'm able to flush the radiator and thermostat. Too cold to do that myself now in February. Think I had a number 3 misfit thats flooding. Haven't looked myself yet but that's what I was told. I don't even know the numbers to each spark plug yet
@LivingWithAClassic4 жыл бұрын
My workshop is not heated so I know what you mean about the cold. If you find oil there, your cam cover gaskets are leaking and you will need to change them too
@breckenridgecaineiii92013 жыл бұрын
@@LivingWithAClassic if it only has oil in the cylinder that is not firing, is that oil being pushed up the sparkplug or a bad gasket there?
@robertbowman34333 жыл бұрын
What is the torque for the 8 intake bolts that hold it down?
@DestinyThompson-j3z11 ай бұрын
Yeah that’s what’s happening with my jag what’s the code for
@stigmoltu-jacobsen4 жыл бұрын
Nice video. Question : I have a 2005 S-Type 2.7 Diesel, also a V6 engine. How does your S-Type petrol V6 engine and diesel differ in terms of the basic layout. I realize there are no spark plugs on a diesel engine.
@LivingWithAClassic4 жыл бұрын
I wish I knew more about the Diesels but the only thing I know is that they are Ford/Peugeut engine that many different companies used. They are suppose to be very realiable.
@janetg16913 жыл бұрын
Why did you change the coil packs?
@LivingWithAClassic3 жыл бұрын
Because they are common to fail. Had one failure so decided to change the ones that are hard to get to
@taunuslunatic4044 жыл бұрын
Next time apply a smear of copper grease on the spark plugs to prevent seizing and hence damage to the threads.
@SMUGEFAKER4 жыл бұрын
Hi Adam, great Video. I feel confident to tackle the same job, same year and model. One slight point, do you have to replace the 2 inlet gaskets?. They weren't mentioned. RSVP Roger
@LivingWithAClassic4 жыл бұрын
Thanks! I reused mine since they looked brand new and they were out of stock when I needed to do it. If your gaskets are old I’d replace them
@deangelowilliams4404 жыл бұрын
I have a 2004 s type can you or anyone help me I need someone who knows the car
@paoladiaz83923 жыл бұрын
I have a Lincoln LS 01 that is the love of my life it is such a female I always need help with little things most of the jobs you can't just do at home
@GerardDucati4 жыл бұрын
Thanks for sharing Adam. Did you do the serpentine belt of this Jag?
@LivingWithAClassic4 жыл бұрын
I have not but I will in the near future. Thanks for watching!
@teekay81342 жыл бұрын
@@LivingWithAClassic Still waiting on the video you promise 😁 on doing the serpentine belt for this Jaguar 👍👍
@markholroyde94129 ай бұрын
@@teekay8134 They never do the hard jobs....without huge cuts in the vid while they go "work it out"...... YT mechanics are hilarious
@PO-ks8xe3 жыл бұрын
I do not know why, but how can you produce an engine in which to change the spark plugs every 30-40 thousand km, you need to remove the entire intake. It must be an English designer 🤪