Jaguar XJ-S Front Subframe Removal, Refresh, Spring Replacement, And More!

[@reinkansman1081]

Aidan your patience and creativity amazes me. Like the way this project is coming together. I hope to ride in it in September.

[@Roscoeverdin5469]

Excellent work. Using the all-thread was pretty ingenious. I hate dealing broken bolts but you took care of it like "A Big Dog"!

[@garrethsmith9000]

Thanks for an informative video. my 1992 4.0l just failed MOT on lower spring pan being rusty. I took the oppertunity to change the springs and shocks. your video helped me put it all back together as I ran out room in my garage and didn't drop the suspension so I had to use the rod method.

[@amosmarrero6213]

You are a bad ass. Can’t wait to see it done. I have a 90 XJS with 9,700 original miles am thinking about taking the v12 anchor out and putting a LS2 I have . Good luck

[@paulschumacher1263]

I am glad your engine-crane is orange--and matches the car. Ditto the jack stands. Fashion-coordination is everything.

[@ericcooper5867]

Mate, the last 2 videos of yours i seen you've had some form of gas exiting your body with your acknowledgement 😂😂 makes it funnier

[@janicehopkins4432]

Using your welder to fix tomato cage - God bless you!

[@stevesmith8180]

My Alfa Romeo Spider Veloce uses the same method on the front springs. I can use a floor jack with the four threaded rods since my subframe is still in the car. I bought the threaded rod from ACE instead of McMaster-Carr

[@alexzildjian]

Excelente trabajo Saludos de Ensenada Baja California MEXICO 👋😉

[@Jeet_Kune_Do_And_Carate]

@4:09 are you farting again? I tell you the truth I heard that in one of your other videos!!! LMAO please clarify!!! Sorry folks but this is too funny, couldn't pass this one up....

[@cosgraham534]

I replayed it multiple times and it is definitely wet fart and not a hub bearing...

[@bluewater7211]

Had me in tears with a fart. To funny

[@sharedinventions]

Regular electric tape is not a permanent solution. It will hardens with time, loose stickiness, further more the sticky thing turns into a messy putty. There are some automotive tapes out there. Other than that, this was a fun video with some metal 🤘.

[@callumduncan6728]

hey if you dont open up between the two pieces of metal on the strut tower you will regret it you MUST kill all the rust in there or it will escalate fast , an instant MOT failure

[@superpeluso1]

Did you fart 💨 in the video 😂

[@Justkevin377]

Did you buy this from Johns cars?

[@Justkevin377]

You should have cleaned under the hood while you pulled all that out.