JBL Control 5 - SPEAKER REFOAM ,SPEAKER REPAIR ,Sicken Reparatur

[@psyne000]

Hi there. I have a control 5 with beading disintergration. What glue were you using for this job. Was it a low tack type wood clue solution ? Nice demo. Thanks for posting.

[@helmanfrow]

You didn't show how to clean the cone.

[@jessegonzalez6929]

Hey mate can you help me with how you opened the speakers? I'm shopping online to buy a bit kit, what size hex screw driver bits did you use? thank you for the help

[@kenthecookieman]

You didn’t show how to remove the grille.

[@BrodaGRCHW]

Few minutes ago i bought a pair of Control 5. It cost something about $5/pair

[@MikeleKonstantyFiedorowiczIV]

in my country they want 100-150$

[@MikeleKonstantyFiedorowiczIV]

but they dont worth it acording to sound from this video

[@diegogilvelutini882]

Sound is very good

[@MAGdeejay]

Hi Ivan Petkov, please help... I have two pairs, they need to be refoamed. Where do I buy the foam? How much could it cost me to repair the four units, by a hifi technician? Thanks in advance, regards from Portugal.

[@deepakpareek9]

If you want I can send you these 4 foam rings from India for free,

[@MAGdeejay]

@@deepakpareek9 thanks a lot, but for free? and the cost of Shipping to Portugal please? Regards...

[@jijisniet]

Don't you clean the underside of the cone?

[@chicagomen01]

yes, obligatory

[@Badassvidsz]

Hi dude i want to ask a quetion about my custom made speakers ; My speakers are 3 way bass reflex tower floor standing type 2x6,5 inches Vifa mid-woofers connected in line 1x4 inches Vifa mid and 1x4 inches Vifa tweeter titanium dome : The crossovers 3 way custom made in relation to the speakers' specs 8 Ohms up to 180 watts each Now each loud-speaker is 90 watts RMS impendance 8 Ohms and sensitivity 94 db My speakers are 20 years old Now the quetion is how many watts each tower is ?? If you can calculate and can have an answer of course :-) My amp is the Yamaha AX-592 100 watts at 8 Ohms and the speakers play undelievably good in very very high volume without any hearable distortion actually never went to the top-volume cause i fear i will break the window glasses but i can see that the amp and the speakers can go up to the top without any problem :-) Thx for any reply much appreciated :-)

[@amitchodankar1989]

What is the diameter of low frequency driver

[@chicagomen01]

6,5 inch

[@修真自悟]

30年前接触过，好声

[@fotograma6588]

Muy bueno!!!

[@klimun9411]

very dirt work...